Never tried Rhino, only using Sangoma...
Rhino are supposed to be zaptel compatible no?
What version of asterisk/zaptel are u using?
Check /proc/zaptel, you should have some instances there.
Does ztcfg -vvvv reports anything ?
Also try changing the pci slot, you might have a IRQ or REQ/GNT conflict.
Patrick Lam wrote:
Andre
yes, i can under lspci....
would it be the zatel driver not compatiable?
pls help
On Thu, May 8, 2008 1:04 pm, Andre Courchesne - Consultant wrote:
Is your card detected by the PCI bridge, meaning does it show when you
do an lspci ?
Patrick Lam wrote:
Hi All,
I recently bought Rhino R1T1 and have problem when i install in Elastix
and
shown unknow?
any idea???? Thanks in advance...
Tested on Elastix 0.9.2 and 1.0.1, results are the same
Card was detected when first plug-in, but status was "unknown" in
System/Hardware Detection tab
Card is no longer detected after "Detect New Hardware" button is pressed
Same result after running "yum update kernel-module-rhino"
Got "Kernel panic" after installing driver from Rhino CD (\Rhino
CDROM\Drivers\RPMS\Elastix\0.8.5_and_above\rhino-2.6.18-8.el5-2.2.1-1.i386.rpm)
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
