There are only 2 pci slots on the m/b. and both behave the same. We tried on another brand m/b, and the same ... :-(
On Thu, May 8, 2008 4:47 pm, Andre Courchesne - Consultant wrote: > That looks a lot like a PCI reset problem... Seen a few of these on PCI > designs basez on Xiling FPGA. Try putting your Rhino card in the PCI > slot closest to the PCI bridge. Or simply try different PCI slots. > > Patrick Lam wrote: >> We do see the Rhino channels, only on a fresh boot. But subsequent >> "Detect >> New Hardware" will wipe out everything in .conf and /proc/zaptel/1 >> >> >> >> >> >> On Thu, May 8, 2008 4:04 pm, Andre Courchesne - Consultant wrote: >> >>> Never tried Rhino, only using Sangoma... >>> >>> Rhino are supposed to be zaptel compatible no? >>> >>> What version of asterisk/zaptel are u using? >>> >>> Check /proc/zaptel, you should have some instances there. >>> >>> Does ztcfg -vvvv reports anything ? >>> >>> Also try changing the pci slot, you might have a IRQ or REQ/GNT >>> conflict. >>> >>> >>> Patrick Lam wrote: >>> >>>> Andre >>>> >>>> yes, i can under lspci.... >>>> would it be the zatel driver not compatiable? >>>> pls help >>>> >>>> >>>> >>>> >>>> On Thu, May 8, 2008 1:04 pm, Andre Courchesne - Consultant wrote: >>>> >>>> >>>>> Is your card detected by the PCI bridge, meaning does it show when >>>>> you >>>>> do an lspci ? >>>>> >>>>> Patrick Lam wrote: >>>>> >>>>> >>>>>> Hi All, >>>>>> >>>>>> I recently bought Rhino R1T1 and have problem when i install in >>>>>> Elastix >>>>>> and >>>>>> shown unknow? >>>>>> any idea???? Thanks in advance... >>>>>> >>>>>> >>>>>> Tested on Elastix 0.9.2 and 1.0.1, results are the same >>>>>> >>>>>> Card was detected when first plug-in, but status was "unknown" in >>>>>> System/Hardware Detection tab >>>>>> >>>>>> Card is no longer detected after "Detect New Hardware" button is >>>>>> pressed >>>>>> >>>>>> Same result after running "yum update kernel-module-rhino" >>>>>> >>>>>> Got "Kernel panic" after installing driver from Rhino CD (\Rhino >>>>>> CDROM\Drivers\RPMS\Elastix\0.8.5_and_above\rhino-2.6.18-8.el5-2.2.1-1.i386.rpm) >>>>>> >>>>>> >>>>>> >>>>>> >>>>>> --------------------------------------------------------------------- >>>>>> To unsubscribe, e-mail: [EMAIL PROTECTED] >>>>>> For additional commands, e-mail: [EMAIL PROTECTED] >>>>>> >>>>>> >>>>>> >>>> >>>> >> >> >> > --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
