One thing, we did not have the "terminator" plug in
On Thu, May 8, 2008 4:04 pm, Andre Courchesne - Consultant wrote: > Never tried Rhino, only using Sangoma... > > Rhino are supposed to be zaptel compatible no? > > What version of asterisk/zaptel are u using? > > Check /proc/zaptel, you should have some instances there. > > Does ztcfg -vvvv reports anything ? > > Also try changing the pci slot, you might have a IRQ or REQ/GNT conflict. > > > Patrick Lam wrote: >> Andre >> >> yes, i can under lspci.... >> would it be the zatel driver not compatiable? >> pls help >> >> >> >> >> On Thu, May 8, 2008 1:04 pm, Andre Courchesne - Consultant wrote: >> >>> Is your card detected by the PCI bridge, meaning does it show when you >>> do an lspci ? >>> >>> Patrick Lam wrote: >>> >>>> Hi All, >>>> >>>> I recently bought Rhino R1T1 and have problem when i install in >>>> Elastix >>>> and >>>> shown unknow? >>>> any idea???? Thanks in advance... >>>> >>>> >>>> Tested on Elastix 0.9.2 and 1.0.1, results are the same >>>> >>>> Card was detected when first plug-in, but status was "unknown" in >>>> System/Hardware Detection tab >>>> >>>> Card is no longer detected after "Detect New Hardware" button is >>>> pressed >>>> >>>> Same result after running "yum update kernel-module-rhino" >>>> >>>> Got "Kernel panic" after installing driver from Rhino CD (\Rhino >>>> CDROM\Drivers\RPMS\Elastix\0.8.5_and_above\rhino-2.6.18-8.el5-2.2.1-1.i386.rpm) >>>> >>>> >>>> >>>> >>>> --------------------------------------------------------------------- >>>> To unsubscribe, e-mail: [EMAIL PROTECTED] >>>> For additional commands, e-mail: [EMAIL PROTECTED] >>>> >>>> >> >> >> > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [EMAIL PROTECTED] > For additional commands, e-mail: [EMAIL PROTECTED] > > --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
