Ah, that did the trick. I set the WAN up with a static IP address, then plugged it into the LAN port.
On 26 May 2010 13:12, Liviu Toma <[email protected]> wrote: > The SPA won't give a dial tone if it's not connected to the network. > If you have a router around that can give it an IP address, that would > do the trick (even if the router's WAN is disconnected). > Also, if you dial a digit, the SPA will go silent but after a few > seconds, if nothing else happens, it will start playing a busy tone. > To increase the digit wait timeout, go to the Regional tab and change > Interdigit Long Timer and Interdigit Short Timer to a high value like > 1000 > > Liviu > > On Wed, May 26, 2010 at 12:34 PM, Dave Donovan <[email protected]> > wrote: >> Simon, >> >> Not sure if you have one of the old orange and blue IAXy boxes but that's >> the default behavior on them. I used to carry one in my kit for exactly >> that purpose. Just give it power and it's a dialtone generator that goes >> silent on a key press. >> >> Dave >> >> On Tue, May 25, 2010 at 9:32 PM, Simon P. Ditner <[email protected]> wrote: >> >>> I had tried that, but it was not giving me a dialtone, just dead air. >>> >>> >>> On Tue, 25 May 2010, Nabeel Jafferali wrote: >>> >>> Turn "dial without register" to yes and set interdigit long and short to >>>> some very large number - I think that should do the trick. >>>> >>>> -- >>>> Nabeel Jafferali >>>> X2 Networks Inc. >>>> >>>> >>>> -----Original Message----- >>>> From: Simon P. Ditner [mailto:[email protected]] >>>> Sent: May-25-10 5:54 PM >>>> To: [email protected] >>>> Subject: [on-asterisk] getting an SPA2102 to generate dialtone without >>>> registering >>>> >>>> I have an SAP2102, and all I want it to do is generate dialtone for some >>>> analog ports I'm testing. Preferably it will just give me silence when I >>>> start dialing digits, and hang there in silence until I hang up. >>>> >>>> Any idea how to configure it to do so without registering with a SIP >>>> proxy? I'd prefer not to have it connected to the network at all after >>>> configuring it. >>>> >>>> Cheers, >>>> spd >>>> >>>> -- >>>> | Simon P. Ditner <[email protected]> / 416-479-0542 / http://taug.ca >>>> | >>>> | Network: >>>> | http://www.facebook.com/spditner >>>> | http://www.linkedin.com/in/spditner >>>> >>>> --------------------------------------------------------------------- >>>> To unsubscribe, e-mail: [email protected] >>>> For additional commands, e-mail: [email protected] >>>> >>>> >>>> --------------------------------------------------------------------- >>>> To unsubscribe, e-mail: [email protected] >>>> For additional commands, e-mail: [email protected] >>>> >>>> >>>> >>> --------------------------------------------------------------------- >>> To unsubscribe, e-mail: [email protected] >>> For additional commands, e-mail: [email protected] >>> >>> >> > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [email protected] > For additional commands, e-mail: [email protected] > > --------------------------------------------------------------------- To unsubscribe, e-mail: [email protected] For additional commands, e-mail: [email protected]
