I'm looking forward to setting up AstLinux on a Alix2c3 myself.
Unfortunately the board that I received had dead ethernet ports so it has
gone back for exchange and the replacement has not arrived yet. I similarly
will use this as SIP uLaw only device, but I will hook in a SPA3000 for
access to an analog POTS line. I've had very poor experience with echo using
this device however... does anyone have a better suggestion for hooking in
just a single analog line to the Alix2c3 -- that doesn't cost an arm and a
leg (like the only mini-PCI solution I found).
Thanks,
David
On Fri, Jun 6, 2008 at 6:25 PM, Darrick Hartman (lists) <
[EMAIL PROTECTED]> wrote:
>
> Sure. Almost all of the zaptel hardware is supported. Specifically,
> Digium, Rhino and Sangoma. There is support for Pika Technology
> hardware, but there are some changes required to get it to compile
> properly. There are a few odd-ball pieces of hardware from OpenVox
> which would require some patching to work, but it's all possible in
> Astlinux.
>
> I have several net5501's with the 8 port Rhino cards (and one install
> with the 24 port card, (7 FXO lines and 3 FXS). The 24 port card won't
> fit in the case, but the 8 port cards fit perfectly.
>
> Darrick
>
> George Masgras wrote:
> > no transcoding, ulaw end to end, SIP only. So you have a zaptel card
> > hooked up to the soekris board? that is awesome, didn't know you could
> > do it with that board and astlinux.
> >
> > On Fri, Jun 6, 2008 at 6:10 PM, Darrick Hartman (lists)
> > <[EMAIL PROTECTED]> wrote:
> >> George Masgras wrote:
> >>> Does anyone have an idea how many SIP phones/active calls/registration
> >>> requests(every 120 sec) an ALIX2c3 with a 1GB card can handle ? This
> >>> would be in PBX only mode. The max I've tried was 4 SIP phones and it
> >>> worked really well, just wanted to know how much I can push this box.
> >>>
> >>> George
> >> George,
> >>
> >> I have several systems installed with the Soekris net5501's with between
> >> 10 and 15 phones. I'd say you can push the box much higher but it
> >> depends on what you're doing. I'm not transcoding. Most of the calls
> >> are terminated on zaptel (dahdi--whatever) hardware with on-board echo
> >> cancellation. If you were transcoding, your mileage may vary.
>
> --
> Darrick Hartman
> DJH Solutions, LLC
> http://www.djhsolutions.com
> http://www.djhsolutions.com/wiki
>
> -------------------------------------------------------------------------
> Check out the new SourceForge.net Marketplace.
> It's the best place to buy or sell services for
> just about anything Open Source.
> http://sourceforge.net/services/buy/index.php
> _______________________________________________
> Astlinux-users mailing list
> Astlinux-users@lists.sourceforge.net
> https://lists.sourceforge.net/lists/listinfo/astlinux-users
>
> Donations to support AstLinux are graciously accepted via PayPal to
> [EMAIL PROTECTED]
>
>
>
-------------------------------------------------------------------------
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services for
just about anything Open Source.
http://sourceforge.net/services/buy/index.php
_______________________________________________
Astlinux-users mailing list
Astlinux-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/astlinux-users
Donations to support AstLinux are graciously accepted via PayPal to [EMAIL
PROTECTED]
