Stephan Monette wrote: > Hi, > > I successfully installed Astlinux 0.6.2 on a compact flash and the > machine is booting up nicely with a Sangoma A200 card installed (with > HWEC and 4x FXO ports). > > I then submit the wanrouter hwprobe command to make sure the system can > detect my Sangoma card and it does : > > pbx ~ # wanrouter hwprobe > > ------------------------------- > | Wanpipe Hardware Probe Info | > ------------------------------- > 1 . AFT-A200-SH : SLOT=0 : BUS=4 : IRQ=9 : CPU=A : PORT=PRI : HWEC=32 : > V=11 > > Card Cnt: A200=1 > > My next step is to issue the wancfg command, but the system always > complain about a missing device w1g1 > > pbx ~ # wancfg > > Sangoma AFT Series card update flash software (version 1.9) > > Get index: w1g1: No such device > w1g1: Failed to create connection > > The information on the website is very simple, I should just issue the > wancfg command from a SSH terminal session (not the console). > > What Am I missing? > > Thanks. >
I'll admit ignorance with respect to Sangoma hardware, but what happens if you modprobe the appropriate module to load the device before running wancfg? That should create the necessary device nodes via udev. Note that I may be way off base here since I don't have a Sangoma card. I'm sure someone else does have one and could respond with a more definitive answer. Philip? I know you have one of their ADSL cards, but I'm assuming configuration would be similar. Darrick ------------------------------------------------------------------------------ This SF.net email is sponsored by: SourcForge Community SourceForge wants to tell your story. http://p.sf.net/sfu/sf-spreadtheword _______________________________________________ Astlinux-users mailing list Astlinux-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/astlinux-users Donations to support AstLinux are graciously accepted via PayPal to pay...@krisk.org.
