Just in case anyone else experiences the same problem provisioning a new box, I am 99.9% sure my original issue (no eth0 or any interfaces besides lo, after 1st reboot during setup sequence) was due to a bad CF card. One of the things I did to finally get the net4801 properly built was to use a different CF.
Just for the hell of it, I tried to install to an alix box last night using my "original" CF from the 4801 installation (of course w/ an alix image) and I had the exact same problem of only having an lo interface after the 1st reboot. Using a different CF card fixed the problem again. -----Original Message----- From: Lonnie Abelbeck [mailto:[email protected]] Sent: Friday, August 24, 2012 11:23 AM To: AstLinux Users Mailing List Subject: Re: [Astlinux-users] Problem w/ new build for Net 4801 Tom, > One more quick question... can you remind me how to configure a bridge > interface. My 4801 has (5) interfaces and I want to bridge eth1 - eth4 for my > LAN interface. I added BRIDGE0="eth1 eth2 eth3 eth4" to rc.conf (via the > "Edit" tab), but after rebooting, I don't see a br0 interface to assign to my > 1st LAN interface. Any suggestions would be appreciated. You need to add: BRIDGE0="eth1 eth2 eth3 eth4" to your /mnt/kd/rc.conf.d/user.conf file via the Network tab... ------------------------------------------------------------------------------ Live Security Virtual Conference Exclusive live event will cover all the ways today's security and threat landscape has changed and how IT managers can respond. Discussions will include endpoint security, mobile security and the latest in malware threats. http://www.accelacomm.com/jaw/sfrnl04242012/114/50122263/ _______________________________________________ Astlinux-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/astlinux-users Donations to support AstLinux are graciously accepted via PayPal to [email protected].
