For CT firmware, IBSS mode works, but again the Rate Control in HT20 mode is not working at all. It always stuck with 6Mbps Tx Rate.
[ 196.030000] ath10k_pci 0000:00:00.0: rx skb 869a5840 len 116 peer 04:f0:21:0c:a5:44 ucast sn 95 rate_idx 0 vht_nss 0 freq 5180 band 1 flag 0x200000 fcs-err 0 mic-err 0 amsdu-more 0 For legacy mode, rate control works. rate_idx to 7 or 54Mbps. [ 156.070000] ath10k_pci 0000:00:00.0: rx skb 86af0900 len 116 peer 04:f0:21:0c:a5:1c ucast sn 95 rate_idx 7 vht_nss 0 freq 5180 band 1 flag 0x200000 fcs-err 0 mic-err 0 amsdu-more 0 Similar to 636 firmware. ---- ChunYeow On Thu, Nov 27, 2014 at 9:04 AM, Yeoh Chun-Yeow <[email protected]> wrote: > On Thu, Nov 27, 2014 at 6:36 AM, Pushpal Sidhu <[email protected]> wrote: >> On Tue, Nov 25, 2014 at 4:59 PM, Ben Greear <[email protected]> wrote: >>> I still cannot get WPA2 encryption to work, but open authentication >>> seems to work fine. I still have a good bit more testing to do. >>> I cannot get ath9k to do encryption in IBSS mode either, so I >>> probably am mis-configuring something. >> >> I don't believe WPA2 is supported with adhoc (at least through >> wpa_supplicant). However, WPA should be and while testing your >> firmware, I found that it doesn't seem to work (They don't see each >> other and thus don't associate). >> >> I also found that, like the 999.x firmware, the rate's do not go >> higher than 54mbit/s. Is this due to the firmware not advertising >> proper rates or..? > > Are you joining the adhoc network in non-HT mode? Anyway, even if you > use HT mode, the rate control is not working for 999.x firmware and > always stuck at 6Mbps as far as I know. > > ----- > Chun-Yeow _______________________________________________ ath10k mailing list [email protected] http://lists.infradead.org/mailman/listinfo/ath10k
