correct me if i'm wrong. but isnt the board data stored in flash memory
on these devices like on every other router i know using ath10k chipsets?
this all sounds a little bit curious for me
Sebastian
Am 27.03.2018 um 09:19 schrieb Sven Eckelmann:
On Dienstag, 27. März 2018 14:48:05 CEST Dongming Han wrote:
I think the ART data is made based on BDF. Maybe the antCtrlCommon logic
and target power parameter is passed to driver by ART but not BDF?
That way we're all happier no need to mantain these change. Please advise.
The antCtrlCommon is part of biModalHeader and this one is taken from the BDF
and not from the pre-cal data (ART). Same is true for the target power limits.
I am only aware of following things which are taken from the pre-cal data
(ART):
* mac
* hal_cal version info
* custData
* regDmn
* txrxMask
* calFreqPier*
* calPierData*
* rxGainCalTbl
* param_for_tuning_caps*
Of course, also the bmi ids are taken from the ART before you load the correct
BDF from the board-2.bin (otherwise, the chip would not know what it actually
is).
Kind regards,
Sven
_______________________________________________
ath10k mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/ath10k
--
Mit freundlichen Grüssen / Regards
Sebastian Gottschall / CTO
NewMedia-NET GmbH - DD-WRT
Firmensitz: Stubenwaldallee 21a, 64625 Bensheim
Registergericht: Amtsgericht Darmstadt, HRB 25473
Geschäftsführer: Peter Steinhäuser, Christian Scheele
http://www.dd-wrt.com
email: [email protected]
Tel.: +496251-582650 / Fax: +496251-5826565
_______________________________________________
ath10k mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/ath10k
