Stephen,
I am using linux 2.6.21. Ath9k supports from 2.6.27 onwards. So, I cant use
the Ath9K drivers. But I need to support AR9280 chips in 2.6.21. We got
some driver for 2.6.15 and I make them compiled for 2.6.21 and using the
".ko".
I am able to start the AP and client is finding the AP, but when client try
to associate, it fails and stats shows following:
/80211stats
3 rx discard 'cuz dup
5 rx discard mgt frames
1 rx frame chan mismatch
990 rx frame ssid mismatch
*11 rx assoc w/ no rate match*
2 active scans started
and iwconfig wlan0 shows as below:
./iwconfig wlan0
wlan0 IEEE 802.11ng ESSID:"rmi_sg" Nickname:""
Mode:Master Frequency:2.417 GHz Access Point: 00:03:7F:0F:E3:23
* Bit Rate=0 kb/s * Tx-Power:16 dBm Sensitivity=1/3
Retry:off RTS thr:off Fragment thr:off
Encryption key:off
Power Management:off
Link Quality=0/94 Signal level=161/162 Noise level=161/161
* Rx invalid nwid:112* Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
So, any guess what may be wrong? If I try setting bitrate using iwconfig,
still it is of no use.
thanks,
MB.
On Wed, Feb 18, 2009 at 12:33 AM, Alex Williams <linuxf...@gmail.com> wrote:
> > Alex, a few questions: what version of ath9k (compat-wireless date?),
> > version of hostapd are you using? What is your ht_capab setting on
> > the AP side? What client chipset and OS are you using?
>
> I'm using wireless-testing git and updating it every day to see
> changes to good side :) I using ar9160 miniPCI card as client + Debian
> Lenny (Linux operating system). Access point (AP) - Level One WBR-6000
> (with 802.11n Draft 2.0)...
>
_______________________________________________
ath9k-devel mailing list
ath9k-devel@lists.ath9k.org
https://lists.ath9k.org/mailman/listinfo/ath9k-devel
