Hi Folks - These are two different sessions, but the result is the same.
http://pastebin.com/g3pLUkVd - tshark dump http://pastebin.com/M22ghcEQ - -dd output The AP is a MI424WR-GEN2. It was supplied by Verizon. Its input is coax or ethernet. It does not do Fiber, even though it has FiOS all over it. It also will not do 802.11N, even though Actiontec's site says it will. Welcome to AOHell! I think his shows a timeing problem. The AP sends an "authenticated" before the request from the "client" goes out. There does not seem to be any "cruft" to crunch in that initial "authenticated" transaction anyway. It always gets by that anyway. It only "associates" when there is a "monitor" virtual interface configured. But then the 4Way fails; reason 2. The packets show one just seconds before. I have not figured out how to dump packets from the AP yet. B. Circa 23:05, 27 May 2014, a note, claiming source Bill Scherr IV <bsch...@cotse.net>, was sent to me: From: "Bill Scherr IV" <bsch...@cotse.net> To: Rajkumar Manoharan <rmano...@qti.qualcomm.com> Date sent: Tue, 27 May 2014 23:05:38 -0400 Priority: normal Copies to: ath9k-de...@venema.h4ckr.net Subject: Re: [ath9k-devel] TDM-4800 is giving me fitZ Send reply to: bsch...@cotse.net > Rajkumar - > > Thanks! I will address that when I return to hostapd. > > Kyle gave me some suggestions, one of which was to see if the hardware > would work as a client. It got an IP address fresh > out of the box from my ISPs AP. I didn't take it any further than that! > > I did spend about 10 minutes browsing the web with NO 802.11 security in > place. It was slow, but everything else I work on > is wired! Everything loaded, so I conclude that the hardware is up to the > job. I have to reconfigure everything again once > WPA_Supp' gets an IP address over it. > > WPA_Supplicant is not completing the four way handshake now! The AP seems > to send everything ahead of WPA_Supp'. It also > only gets to the 4-way when I have a monitor I/F configured. The RF readings > bely belief, but I think I can get a good ground > in that room to clean things up! > > I had to do a lot of reconfiguring to get all of the security functions > out of the way. Digging through all of that, and > making it presentable is gonna take some time. Oh, and I have paycheck to > earn outside of this. > > I appreciate your time! My future evidence will be much more effective! > Crawl, Walk, Run as they say! > > B. > > Circa 10:44, 26 May 2014, a note, claiming source Rajkumar Manoharan > <rmano...@qti.qualcomm.com>, was sent to me: > > Date sent: Mon, 26 May 2014 10:44:59 +0530 > From: Rajkumar Manoharan <rmano...@qti.qualcomm.com> > To: Bill Scherr IV <bsch...@cotse.net> > Copies to: Kyle Bassett <kylebass...@gmail.com>, > <ath9k-de...@venema.h4ckr.net> > Subject: Re: [ath9k-devel] TDM-4800 is giving me fitZ > > > On Sun, May 25, 2014 at 05:32:53PM -0400, Bill Scherr IV wrote: > > > > Bill, > > > > The beacon interval is conflicting b/w hostapd config and the driver's > > beacon interval. > > I am wondering how the driver is getting configured with 2 seconds beacon > > interval. > > > > > nl80211: beacon_int=100 > > > > > > > May 24 22:28:28 hosta kernel: [77898.162347] ath: phy0: AP (Enable) > > > > > nexttbtt: 2106368 intval: 263296 conf_intval: 2057 > > > > -Rajkumar > > > > > > > Bill Scherr IV, GSEC, GCIA > Principal Security Engineer > EWA Information and Infrastructure Technologies > bsch...@iit-tek.com > bsch...@ewa.com > 703-478-7608 > > > _______________________________________________ > ath9k-devel mailing list > ath9k-devel@lists.ath9k.org > https://lists.ath9k.org/mailman/listinfo/ath9k-devel > > Bill Scherr IV, GSEC, GCIA Principal Security Engineer EWA Information and Infrastructure Technologies bsch...@iit-tek.com bsch...@ewa.com 703-478-7608 _______________________________________________ ath9k-devel mailing list ath9k-devel@lists.ath9k.org https://lists.ath9k.org/mailman/listinfo/ath9k-devel
