Graham Davies wrote:
Well, try using JTAG to set the clock fuses back to the internal
clock. Or,
do a full chip erase. If you can get into the MCU with JTAG and do an
erase
and your problem persists, I don't think the problem can be in the MCU
and
you then need to look elsewhere. Unless the MCU is fried.
That´s the problem. Both programmers (stk500 and avrdude) gives an error
if I will write into the flash.
stk500 says: "Could not enter programming mode"
avrdude says: "stk500_2_ReceiveMessage(): timeout" and "verification
error, first mismatch at byte 0x0000 0x90 != 0x08" after writing 0x90
to hfuse
(please see my logging in my first email)
I will not hope that my board is "fried".
Thomas
_______________________________________________
AVR-chat mailing list
[email protected]
http://lists.nongnu.org/mailman/listinfo/avr-chat
