Rafal,
-----Original Message----- >From: Rafał Miłecki <[email protected]> >Sent: Sep 24, 2010 2:27 PM >To: [email protected] >Cc: [email protected] >Subject: Re: Is this card supported? > >2010/9/24 <[email protected]>: >> Hi, ALL, >> This is an information about the hardware: >> >> IgorsGentooWork OE # uname -a >> Linux IgorsGentooWork 2.6.32-gentoo-r7 #4 Mon Jul 5 13:42:27 PDT 2010 i686 >> Intel(R) Celeron(R) M processor 1.50GHz GenuineIntel GNU/Linux >> >> IgorsGentooWork OE # lspci -vnn | grep 14e4 >> 02:00.0 Ethernet controller [0200]: Broadcom Corporation BCM4401-B0 >> 100Base-TX [14e4:170c] (rev 02) >> 02:03.0 Network controller [0280]: Broadcom Corporation BCM4318 [AirForce >> One 54g] 802.11g Wireless LAN Controller [14e4:4318] (rev 02) >> >> Is this device supported? > >http://wireless.kernel.org/en/users/Drivers/b43 Can you then explain this: IgorsGentooWork OE # ifconfig wlan0 up IgorsGentooWork OE # iwconfig wlan0 essid "GoogleWiFi" Cannot read /proc/net/wireless Error for wireless request "Set ESSID" (8B1A) : SET failed on device wlan0 ; Invalid argument. IgorsGentooWork OE # man iwconfig IgorsGentooWork OE # iwconfig wlan0 scan iwconfig: unknown command "scan" IgorsGentooWork OE # ifconfig wlan0 scan scan: Unknown host ifconfig: `--help' gives usage information. IgorsGentooWork OE # man ifconfig IgorsGentooWork OE # ifconfig -a eth0 Link encap:Ethernet HWaddr 00:14:22:aa:cc:69 inet addr:192.168.2.141 Bcast:192.168.2.255 Mask:255.255.255.0 inet6 addr: fe80::214:22ff:feaa:cc69/64 Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:2403559 errors:0 dropped:0 overruns:0 frame:0 TX packets:2084228 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:2352559614 (2.1 GiB) TX bytes:766927573 (731.3 MiB) Interrupt:9 lo Link encap:Local Loopback inet addr:127.0.0.1 Mask:255.0.0.0 inet6 addr: ::1/128 Scope:Host UP LOOPBACK RUNNING MTU:16436 Metric:1 RX packets:28 errors:0 dropped:0 overruns:0 frame:0 TX packets:28 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:2592 (2.5 KiB) TX bytes:2592 (2.5 KiB) sit0 Link encap:IPv6-in-IPv4 NOARP MTU:1480 Metric:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:0 (0.0 B) TX bytes:0 (0.0 B) wlan0 Link encap:Ethernet HWaddr 00:16:ce:1d:9f:32 UP BROADCAST MULTICAST MTU:1500 Metric:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:0 (0.0 B) TX bytes:0 (0.0 B) dmesg says: IgorsGentooWork OE # dmesg | tail [4995866.378984] b43 ssb0:0: firmware: requesting b43/b0g0bsinitvals5.fw [4995866.379706] PM: Adding info for No Bus:ssb0:0 [4995866.407533] PM: Removing info for No Bus:ssb0:0 [4995866.534044] b43-phy0: Loading firmware version 410.2160 (2007-05-26 15:32:10) [4995866.566088] b43-phy0 debug: Chip initialized [4995866.566283] b43-phy0 debug: 32-bit DMA initialized [4995866.566357] b43-phy0 debug: QoS enabled [4995866.577067] b43-phy0 debug: Wireless interface started [4995866.577076] b43-phy0 debug: Adding Interface type 2 [4995866.577633] ADDRCONF(NETDEV_UP): wlan0: link is not ready Thank you. P.S.: Just so that nobody will be bothered I will add the ML to whitelist.. ;-) > >-- >Rafał _______________________________________________ b43-dev mailing list [email protected] http://lists.infradead.org/mailman/listinfo/b43-dev
