Hi,
-----Original Message----- >From: Gábor Stefanik <[email protected]> >Sent: Sep 25, 2010 6:23 PM >To: [email protected] >Cc: Rafał Miłecki <[email protected]>, [email protected] >Subject: Re: Is this card supported? > >2010/9/25 <[email protected]>: >> Rafal, >> >> >> -----Original Message----- >>>From: Rafał Miłecki <[email protected]> >>>Sent: Sep 24, 2010 2:27 PM >>>To: [email protected] >>>Cc: [email protected] >>>Subject: Re: Is this card supported? >>> >>>2010/9/24 <[email protected]>: >>>> Hi, ALL, >>>> This is an information about the hardware: >>>> >>>> IgorsGentooWork OE # uname -a >>>> Linux IgorsGentooWork 2.6.32-gentoo-r7 #4 Mon Jul 5 13:42:27 PDT 2010 i686 >>>> Intel(R) Celeron(R) M processor 1.50GHz GenuineIntel GNU/Linux >>>> >>>> IgorsGentooWork OE # lspci -vnn | grep 14e4 >>>> 02:00.0 Ethernet controller [0200]: Broadcom Corporation BCM4401-B0 >>>> 100Base-TX [14e4:170c] (rev 02) >>>> 02:03.0 Network controller [0280]: Broadcom Corporation BCM4318 [AirForce >>>> One 54g] 802.11g Wireless LAN Controller [14e4:4318] (rev 02) >>>> >>>> Is this device supported? >>> >>>http://wireless.kernel.org/en/users/Drivers/b43 >> >> Can you then explain this: >> >> IgorsGentooWork OE # ifconfig wlan0 up >> IgorsGentooWork OE # iwconfig wlan0 essid "GoogleWiFi" >> Cannot read /proc/net/wireless > >Let me guess: procfs is not mounted. You guessed wrong: procfs is mounted: /dev/hda3 on / type ext3 (rw,noatime) proc on /proc type proc (rw,nosuid,nodev,noexec,relatime) sysfs on /sys type sysfs (rw,nosuid,nodev,noexec,relatime) udev on /dev type tmpfs (rw,nosuid,relatime,size=10240k,mode=755) devpts on /dev/pts type devpts (rw,nosuid,noexec,relatime,gid=5,mode=620) shm on /dev/shm type tmpfs (rw,noexec,nosuid,nodev) usbfs on /proc/bus/usb type usbfs (rw,noexec,nosuid,devmode=0664,devgid=85) binfmt_misc on /proc/sys/fs/binfmt_misc type binfmt_misc (rw,noexec,nosuid,nodev) Any other ideas? Thank you. > >> Error for wireless request "Set ESSID" (8B1A) : >> SET failed on device wlan0 ; Invalid argument. >> IgorsGentooWork OE # man iwconfig >> IgorsGentooWork OE # iwconfig wlan0 scan >> iwconfig: unknown command "scan" >> IgorsGentooWork OE # ifconfig wlan0 scan >> scan: Unknown host >> ifconfig: `--help' gives usage information. >> IgorsGentooWork OE # man ifconfig >> IgorsGentooWork OE # ifconfig -a >> eth0 Link encap:Ethernet HWaddr 00:14:22:aa:cc:69 >> inet addr:192.168.2.141 Bcast:192.168.2.255 Mask:255.255.255.0 >> inet6 addr: fe80::214:22ff:feaa:cc69/64 Scope:Link >> UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 >> RX packets:2403559 errors:0 dropped:0 overruns:0 frame:0 >> TX packets:2084228 errors:0 dropped:0 overruns:0 carrier:0 >> collisions:0 txqueuelen:1000 >> RX bytes:2352559614 (2.1 GiB) TX bytes:766927573 (731.3 MiB) >> Interrupt:9 >> >> lo Link encap:Local Loopback >> inet addr:127.0.0.1 Mask:255.0.0.0 >> inet6 addr: ::1/128 Scope:Host >> UP LOOPBACK RUNNING MTU:16436 Metric:1 >> RX packets:28 errors:0 dropped:0 overruns:0 frame:0 >> TX packets:28 errors:0 dropped:0 overruns:0 carrier:0 >> collisions:0 txqueuelen:0 >> RX bytes:2592 (2.5 KiB) TX bytes:2592 (2.5 KiB) >> >> sit0 Link encap:IPv6-in-IPv4 >> NOARP MTU:1480 Metric:1 >> RX packets:0 errors:0 dropped:0 overruns:0 frame:0 >> TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 >> collisions:0 txqueuelen:0 >> RX bytes:0 (0.0 B) TX bytes:0 (0.0 B) >> >> wlan0 Link encap:Ethernet HWaddr 00:16:ce:1d:9f:32 >> UP BROADCAST MULTICAST MTU:1500 Metric:1 >> RX packets:0 errors:0 dropped:0 overruns:0 frame:0 >> TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 >> collisions:0 txqueuelen:1000 >> RX bytes:0 (0.0 B) TX bytes:0 (0.0 B) >> >> dmesg says: >> >> IgorsGentooWork OE # dmesg | tail >> [4995866.378984] b43 ssb0:0: firmware: requesting b43/b0g0bsinitvals5.fw >> [4995866.379706] PM: Adding info for No Bus:ssb0:0 >> [4995866.407533] PM: Removing info for No Bus:ssb0:0 >> [4995866.534044] b43-phy0: Loading firmware version 410.2160 (2007-05-26 >> 15:32:10) >> [4995866.566088] b43-phy0 debug: Chip initialized >> [4995866.566283] b43-phy0 debug: 32-bit DMA initialized >> [4995866.566357] b43-phy0 debug: QoS enabled >> [4995866.577067] b43-phy0 debug: Wireless interface started >> [4995866.577076] b43-phy0 debug: Adding Interface type 2 >> [4995866.577633] ADDRCONF(NETDEV_UP): wlan0: link is not ready >> >> Thank you. >> >> P.S.: Just so that nobody will be bothered I will add the ML to >> whitelist.. ;-) >> >>> >>>-- >>>Rafał >> >> >> _______________________________________________ >> b43-dev mailing list >> [email protected] >> http://lists.infradead.org/mailman/listinfo/b43-dev >> > > > >-- >Vista: [V]iruses, [I]ntruders, [S]pyware, [T]rojans and [A]dware. :-) _______________________________________________ b43-dev mailing list [email protected] http://lists.infradead.org/mailman/listinfo/b43-dev
