2010/9/25 <[email protected]>: > Rafal, > > > -----Original Message----- >>From: Rafał Miłecki <[email protected]> >>Sent: Sep 24, 2010 2:27 PM >>To: [email protected] >>Cc: [email protected] >>Subject: Re: Is this card supported? >> >>2010/9/24 <[email protected]>: >>> Hi, ALL, >>> This is an information about the hardware: >>> >>> IgorsGentooWork OE # uname -a >>> Linux IgorsGentooWork 2.6.32-gentoo-r7 #4 Mon Jul 5 13:42:27 PDT 2010 i686 >>> Intel(R) Celeron(R) M processor 1.50GHz GenuineIntel GNU/Linux >>> >>> IgorsGentooWork OE # lspci -vnn | grep 14e4 >>> 02:00.0 Ethernet controller [0200]: Broadcom Corporation BCM4401-B0 >>> 100Base-TX [14e4:170c] (rev 02) >>> 02:03.0 Network controller [0280]: Broadcom Corporation BCM4318 [AirForce >>> One 54g] 802.11g Wireless LAN Controller [14e4:4318] (rev 02) >>> >>> Is this device supported? >> >>http://wireless.kernel.org/en/users/Drivers/b43 > > Can you then explain this: > > IgorsGentooWork OE # ifconfig wlan0 up > IgorsGentooWork OE # iwconfig wlan0 essid "GoogleWiFi" > Cannot read /proc/net/wireless
Let me guess: procfs is not mounted. > Error for wireless request "Set ESSID" (8B1A) : > SET failed on device wlan0 ; Invalid argument. > IgorsGentooWork OE # man iwconfig > IgorsGentooWork OE # iwconfig wlan0 scan > iwconfig: unknown command "scan" > IgorsGentooWork OE # ifconfig wlan0 scan > scan: Unknown host > ifconfig: `--help' gives usage information. > IgorsGentooWork OE # man ifconfig > IgorsGentooWork OE # ifconfig -a > eth0 Link encap:Ethernet HWaddr 00:14:22:aa:cc:69 > inet addr:192.168.2.141 Bcast:192.168.2.255 Mask:255.255.255.0 > inet6 addr: fe80::214:22ff:feaa:cc69/64 Scope:Link > UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 > RX packets:2403559 errors:0 dropped:0 overruns:0 frame:0 > TX packets:2084228 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:1000 > RX bytes:2352559614 (2.1 GiB) TX bytes:766927573 (731.3 MiB) > Interrupt:9 > > lo Link encap:Local Loopback > inet addr:127.0.0.1 Mask:255.0.0.0 > inet6 addr: ::1/128 Scope:Host > UP LOOPBACK RUNNING MTU:16436 Metric:1 > RX packets:28 errors:0 dropped:0 overruns:0 frame:0 > TX packets:28 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:0 > RX bytes:2592 (2.5 KiB) TX bytes:2592 (2.5 KiB) > > sit0 Link encap:IPv6-in-IPv4 > NOARP MTU:1480 Metric:1 > RX packets:0 errors:0 dropped:0 overruns:0 frame:0 > TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:0 > RX bytes:0 (0.0 B) TX bytes:0 (0.0 B) > > wlan0 Link encap:Ethernet HWaddr 00:16:ce:1d:9f:32 > UP BROADCAST MULTICAST MTU:1500 Metric:1 > RX packets:0 errors:0 dropped:0 overruns:0 frame:0 > TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:1000 > RX bytes:0 (0.0 B) TX bytes:0 (0.0 B) > > dmesg says: > > IgorsGentooWork OE # dmesg | tail > [4995866.378984] b43 ssb0:0: firmware: requesting b43/b0g0bsinitvals5.fw > [4995866.379706] PM: Adding info for No Bus:ssb0:0 > [4995866.407533] PM: Removing info for No Bus:ssb0:0 > [4995866.534044] b43-phy0: Loading firmware version 410.2160 (2007-05-26 > 15:32:10) > [4995866.566088] b43-phy0 debug: Chip initialized > [4995866.566283] b43-phy0 debug: 32-bit DMA initialized > [4995866.566357] b43-phy0 debug: QoS enabled > [4995866.577067] b43-phy0 debug: Wireless interface started > [4995866.577076] b43-phy0 debug: Adding Interface type 2 > [4995866.577633] ADDRCONF(NETDEV_UP): wlan0: link is not ready > > Thank you. > > P.S.: Just so that nobody will be bothered I will add the ML to > whitelist.. ;-) > >> >>-- >>Rafał > > > _______________________________________________ > b43-dev mailing list > [email protected] > http://lists.infradead.org/mailman/listinfo/b43-dev > -- Vista: [V]iruses, [I]ntruders, [S]pyware, [T]rojans and [A]dware. :-) _______________________________________________ b43-dev mailing list [email protected] http://lists.infradead.org/mailman/listinfo/b43-dev
