Hello, So all btape tests except the autochanger test were successful using the defaul
On Fri, Jan 20, 2023 at 4:49 AM Gary R. Schmidt <g...@mcleod-schmidt.id.au> wrote: > On 20/01/2023 04:30, Lee Damon wrote: > > We recently replaced a working LTO5 + Scalar i40 jukebox with an IBM > > LTO8 tape + Scalar i3 jukebox. The controller and all software remained > > the same. I am suspecting a configuration problem and would greatly > > appreciate guidance. > > > > When I tried to label the new tapes it loaded the first one fine, labled > > it fine, then failed miserably to unload it. I tried adding the "Offline > > On Unmount" command to the config (see below) but that didn't help. > > > > I then tried running > > /usr/bin/sudo /sbin/btape -c /etc/bacula/bacula-sd.conf /dev/tape/0 > > which worked fine until it got to the 'test the autochanger' part of the > > test, > > then failed just as miserably. The results are different (I/O errors) if > > the unmount > > setting is there, but it fails either way. > > > > I'll attach two script files that show various btape runs. Note that > between > > the tests I did the following reset: > > sudo mt -f /dev/tape/0 rewoffl > > sudo mtx -f /dev/changer/0 unload 1 > > sudo mtx -f /dev/changer/0 load 1 > > > > Nothing interesting shows up in the system logs. > > > I would turn on debug in mtx-changer.conf - set debug_level=100 - and > see what comes out. > > Cheers, > Gary B-) > > > _______________________________________________ > Bacula-users mailing list > Bacula-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/bacula-users >
_______________________________________________ Bacula-users mailing list Bacula-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/bacula-users