Hi J,
On 01/21/2015 05:56 PM, Jean-Christophe PLAGNIOL-VILLARD wrote:
On Jan 21, 2015, at 5:41 PM, Sascha Hauer <[email protected]> wrote:
On Tue, Jan 20, 2015 at 03:31:25PM +0800, Bo Shen wrote:
As the 1-wire and LED d2 use the same pin (PE25) on the EK board.
So, make LED enable only when the 1-wire is disabled.
Signed-off-by: Bo Shen <[email protected]>
---
arch/arm/boards/sama5d3xek/init.c | 8 ++++++++
1 file changed, 8 insertions(+)
On barebox this does not conflict
As both use gpio mode, which will call gpio request, when LED try to
request the same gpio, it will failed. So, the led d2 won't be
successfully registered.
as we do not have multi task support
Best Regards,
J.
Applied, thanks
Sascha
--
Pengutronix e.K. | |
Industrial Linux Solutions | http://www.pengutronix.de/ |
Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0 |
Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 |
Best Regards,
Bo Shen
_______________________________________________
barebox mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/barebox
