Hi J,
On 01/23/2015 03:58 PM, Jean-Christophe PLAGNIOL-VILLARD wrote:
On Jan 21, 2015, at 6:03 PM, Bo Shen <[email protected]> wrote:
Hi J,
On 01/21/2015 05:56 PM, Jean-Christophe PLAGNIOL-VILLARD wrote:
On Jan 21, 2015, at 5:41 PM, Sascha Hauer <[email protected]> wrote:
On Tue, Jan 20, 2015 at 03:31:25PM +0800, Bo Shen wrote:
As the 1-wire and LED d2 use the same pin (PE25) on the EK board.
So, make LED enable only when the 1-wire is disabled.
Signed-off-by: Bo Shen <[email protected]>
---
arch/arm/boards/sama5d3xek/init.c | 8 ++++++++
1 file changed, 8 insertions(+)
On barebox this does not conflict
As both use gpio mode, which will call gpio request, when LED try to request
the same gpio, it will failed. So, the led d2 won't be successfully registered.
Yes with the pinctrl driver
but it will be a choice at defconfig level not C code
if you enable both we need to put a warning at compiling time
I don't find any good solution for this, can you provide one? Thanks.
and decide which one is more important because if you do not use the w1 you may
do except to have both legs
Actually, in code, no use for led d2, only d1 heart beat.
as we do not have multi task support
Best Regards,
J.
Applied, thanks
Sascha
--
Pengutronix e.K. | |
Industrial Linux Solutions | http://www.pengutronix.de/ |
Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0 |
Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 |
Best Regards,
Bo Shen
Best Regards,
Bo Shen
_______________________________________________
barebox mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/barebox
