Larry, -----Original Message----- >From: Larry Finger <[EMAIL PROTECTED]> >Sent: Jan 28, 2007 6:17 PM >To: Igor Korot <[EMAIL PROTECTED]> >Cc: Michael Buesch <[EMAIL PROTECTED]>, [email protected] >Subject: Re: Problem with the lid closing event > >Igor Korot wrote: >> Hi, Larry, >> I did a quick test and, indeed, the value calculation is the same in both >> cases. Sorry about the confusion. >> >> However, I found another problem. >> I am running Gentoo with 2.6.18 kernel with the LED activation and interrupt >> enabled patches. >> After running "ifconfig eth1 up", the card is up, the WiFi LED is on, and >> everything works as expected. >> >> However, when I close and re-open the lid of my laptop, I lost the ability >> to restore it. >> >> I am not running the suspend software, I have a 'vbetool' installed on top >> of GNOME. >> Since evrything was working, I was able to capture the dmesg output, which >> is attached. >> > >I didn't see anything in the log that indicates an error. Is this dmesg output >from before or after >the lid closing? I don't see either the suspend or resume debug messages from >bcm43xx.
This dmesg is after the lid has been open. The WiFi LED was still "on". However, the screen was not restored. > >There is a report of bcm43xx not resuming correctly after suspend to disk. >Unfortunately, my >graphics system crashes when I try to suspend and I have to do a power off. >That prevents me from >testing the suspend or resume code. It might be the same issue, or the different one. You can try to install the vbetool on you laptop, and check if it won't crash. Then we can check for the bcm43xx driver behavior.... > >Larry Thank you. _______________________________________________ Bcm43xx-dev mailing list [email protected] https://lists.berlios.de/mailman/listinfo/bcm43xx-dev
