Larry, -----Original Message----- >From: Igor Korot <[EMAIL PROTECTED]> >Sent: Jan 28, 2007 8:14 PM >To: Larry Finger <[EMAIL PROTECTED]> >Cc: Michael Buesch <[EMAIL PROTECTED]>, [email protected] >Subject: Re: Problem with the lid closing event > >Larry, > >-----Original Message----- >>From: Larry Finger <[EMAIL PROTECTED]> >>Sent: Jan 28, 2007 6:17 PM >>To: Igor Korot <[EMAIL PROTECTED]> >>Cc: Michael Buesch <[EMAIL PROTECTED]>, [email protected] >>Subject: Re: Problem with the lid closing event >> >>Igor Korot wrote: >>> Hi, Larry, >>> I did a quick test and, indeed, the value calculation is the same in both >>> cases. Sorry about the confusion. >>> >>> However, I found another problem. >>> I am running Gentoo with 2.6.18 kernel with the LED activation and >>> interrupt enabled patches. >>> After running "ifconfig eth1 up", the card is up, the WiFi LED is on, and >>> everything works as expected. >>> >>> However, when I close and re-open the lid of my laptop, I lost the ability >>> to restore it. >>> >>> I am not running the suspend software, I have a 'vbetool' installed on top >>> of GNOME. >>> Since evrything was working, I was able to capture the dmesg output, which >>> is attached. >>> >> >>I didn't see anything in the log that indicates an error. Is this dmesg >>output from before or after >>the lid closing? I don't see either the suspend or resume debug messages from >>bcm43xx. > >This dmesg is after the lid has been open. The WiFi LED was still "on". >However, the screen was not restored. > >> >>There is a report of bcm43xx not resuming correctly after suspend to disk. >>Unfortunately, my >>graphics system crashes when I try to suspend and I have to do a power off. >>That prevents me from >>testing the suspend or resume code. > >It might be the same issue, or the different one. >You can try to install the vbetool on you laptop, and check if it won't crash. >Then we can check for the bcm43xx driver behavior....
This is the software I installed: http://www.srcf.ucam.org/~mjg59/vbetool/ Maybe it will run fine on you video. Also, I tried to turn the card on, then off, and then close/open the lid. It didn't work as well. Which means that any card activity stops this software from restoring the screen. Thank you. > >> >>Larry > >Thank you. _______________________________________________ Bcm43xx-dev mailing list [email protected] https://lists.berlios.de/mailman/listinfo/bcm43xx-dev
