Igor Korot wrote: > Larry, > > -----Original Message----- >> From: Igor Korot <[EMAIL PROTECTED]> >> Sent: Jan 28, 2007 8:14 PM >> To: Larry Finger <[EMAIL PROTECTED]> >> Cc: Michael Buesch <[EMAIL PROTECTED]>, Bcm43xx-dev@lists.berlios.de >> Subject: Re: Problem with the lid closing event >> >> Larry, >> >> -----Original Message----- >>> From: Larry Finger <[EMAIL PROTECTED]> >>> Sent: Jan 28, 2007 6:17 PM >>> To: Igor Korot <[EMAIL PROTECTED]> >>> Cc: Michael Buesch <[EMAIL PROTECTED]>, Bcm43xx-dev@lists.berlios.de >>> Subject: Re: Problem with the lid closing event >>> >>> Igor Korot wrote: >>>> Hi, Larry, >>>> I did a quick test and, indeed, the value calculation is the same in both >>>> cases. Sorry about the confusion. >>>> >>>> However, I found another problem. >>>> I am running Gentoo with 2.6.18 kernel with the LED activation and >>>> interrupt enabled patches. >>>> After running "ifconfig eth1 up", the card is up, the WiFi LED is on, and >>>> everything works as expected. >>>> >>>> However, when I close and re-open the lid of my laptop, I lost the ability >>>> to restore it. >>>> >>>> I am not running the suspend software, I have a 'vbetool' installed on top >>>> of GNOME. >>>> Since evrything was working, I was able to capture the dmesg output, which >>>> is attached. >>>> >>> I didn't see anything in the log that indicates an error. Is this dmesg >>> output from before or after >>> the lid closing? I don't see either the suspend or resume debug messages >>> from bcm43xx. >> This dmesg is after the lid has been open. The WiFi LED was still "on". >> However, the screen was not restored. >> >>> There is a report of bcm43xx not resuming correctly after suspend to disk. >>> Unfortunately, my >>> graphics system crashes when I try to suspend and I have to do a power off. >>> That prevents me from >>> testing the suspend or resume code. >> It might be the same issue, or the different one. >> You can try to install the vbetool on you laptop, and check if it won't >> crash. >> Then we can check for the bcm43xx driver behavior.... > > This is the software I installed: > http://www.srcf.ucam.org/~mjg59/vbetool/
It won't even compile here. Perhaps it is because I have an x86_64 system. I don't have time to debug that program. Larry _______________________________________________ Bcm43xx-dev mailing list Bcm43xx-dev@lists.berlios.de https://lists.berlios.de/mailman/listinfo/bcm43xx-dev
