Francesco Gringoli wrote: > just one more question: if you have time to test again r5.1, not a > stress test, a wget is enough, could you please report info about rx and > tx_ring usages? Those lines like the following: > > [219861.208427] b43-phy222 debug: DMA-32 rx_ring: Used slots 8/64, > Failed frames 0/0 = 0.0%, Average tries 0.00 > [219861.216070] b43-phy222 debug: DMA-32 tx_ring_AC_BE: Used slots > 128/128, Failed frames 1600/3398448 = 0.0%, Average tries 1.19
I downloaded the 2.6.28.tar.gz file ffrom kernel.org - about 64 MiB. The logged data are ssb: Core 3 found: PCMCIA (cc 0x80D, rev 0x07, vendor 0x4243) ssb: SPROM revision 2 detected. b43-phy1: Broadcom 4318 WLAN found (core revision 9) b43-phy1 debug: Found PHY: Analog 3, Type 2, Revision 7 b43-phy1 debug: Found Radio: Manuf 0x17F, Version 0x2050, Revision 8 wmaster0 (b43): not using net_device_ops yet phy1: Selected rate control algorithm 'minstrel' ssb: Sonics Silicon Backplane found on PCI device 0000:06:00.0 udev: renamed network interface wlan0 to eth1 input: b43-phy1 as /class/input/input5 b43 ssb1:0: firmware: requesting b43-open/ucode5.fw b43 ssb1:0: firmware: requesting b43-open/pcm5.fw b43 ssb1:0: firmware: requesting b43-open/b0g0initvals5.fw b43 ssb1:0: firmware: requesting b43-open/b0g0bsinitvals5.fw b43-phy1: Loading OpenSource firmware version 410.31754 (Hardware crypto not supported) b43-phy1 debug: Chip initialized b43-phy1 debug: 32-bit DMA initialized b43-phy1 debug: Wireless interface started b43-phy1 debug: Adding Interface type 2 b43-phy1: Radio turned on by software eth1: authenticate with AP 00:1a:70:46:ba:b1 eth1: authenticated eth1: associate with AP 00:1a:70:46:ba:b1 eth1: RX AssocResp from 00:1a:70:46:ba:b1 (capab=0x431 status=0 aid=2) eth1: associated eth1: deauthenticating by local choice (reason=3) b43-phy1 debug: Removing Interface type 2 b43-phy1 debug: Wireless interface stopped b43-phy1 debug: DMA-32 rx_ring: Used slots 4/64, Failed frames 0/0 = 0.0%, Average tries 0.00 b43-phy1 debug: DMA-32 tx_ring_AC_BK: Used slots 0/128, Failed frames 0/0 = 0.0%, Average tries 0.00 b43-phy1 debug: DMA-32 tx_ring_AC_BE: Used slots 24/128, Failed frames 0/24835 = 0.0%, Average tries 1.02 b43-phy1 debug: DMA-32 tx_ring_AC_VI: Used slots 0/128, Failed frames 0/0 = 0.0%, Average tries 0.00 b43-phy1 debug: DMA-32 tx_ring_AC_VO: Used slots 0/128, Failed frames 0/0 = 0.0%, Average tries 0.00 b43-phy1 debug: DMA-32 tx_ring_mcast: Used slots 0/128, Failed frames 0/0 = 0.0%, Average tries 0.00 b43-pci-bridge 0000:06:00.0: PCI INT A disabled Larry _______________________________________________ Bcm43xx-dev mailing list [email protected] https://lists.berlios.de/mailman/listinfo/bcm43xx-dev
