Miklos Vajna wrote: > > reboot pending to try the latest wireless-testing, > > Please let me know if that helped (which git repo, which branch?).
It did not help. I merged git://git.kernel.org/pub/scm/linux/kernel/git/linville/wireless-testing.git master into my kernel, and have posted a message about it to the ath9k list. Miklos Vajna wrote: > So it's like: it's avilable for about 5 secs, then it goes down for > 2, and this loops forever. :/ My disconnects are nowhere nearly as frequent. I can provoke them with power management on but with it off my card is very usable. I suspect there may be a similar problem in the reception path of both ath9k and b43, leading to the same error in mac80211. > Again, this is with 2.6.33-rc4. Now my hope is that > wireless-testing has some changes which are not in 2.6.33-rc4 and > that solves this issue, but I'll wait for your experience first. :) Not for me, but I'm also not exercising the b43 code at all, so maybe there is something for you.. Dunno. $ git log --oneline dec18..master drivers/net/wireless/b43|grep b43: 81f14df b43: LP-PHY: note and explain specs inconsistency 55afc80 Revert "b43: Enforce DMA descriptor memory constraints" b02914a b43: Allow PIO mode to be selected at module load 214ac9a b43: Remove reset after fatal DMA error df98a49 b43: fix two warnings c2ff581 b43: avoid PPC fault during resume 07681e2 b43: Rewrite DMA Tx status handling sanity checks 9bd568a b43: Enforce DMA descriptor memory constraints f54a520 b43: Rewrite TX bounce buffer handling c1b84ab b43: Remove deprecated 'qual' from returned RX status 2c0d610 b43: LP-PHY: Begin implementing calibration & software RFKILL support 72f5f45 b43: use ieee80211_rx_ni() 88499ab b43: Optimize PIO scratchbuffer usage bdcf8ff b43: Comment unused functions lpphy_restore_dig_flt_state and lpphy_disable_rx_gain_override //Peter _______________________________________________ Bcm43xx-dev mailing list Bcm43xx-dev@lists.berlios.de https://lists.berlios.de/mailman/listinfo/bcm43xx-dev