Tom, one more question: What tag I should use as base for those patches? I checked the first patch of the first v2 patch sets (http://patchwork.ozlabs.org/patch/266966/) against u-boot-denx 2013.04 git tree that Ångström distribution u-boot-denx recipe provides. It seems that last patch operation applied to ../drivers/mtd/nand/omap_gpmc.c must fail as there is no matching pattern in that file. So, should I use more up-to-date tag like 2013.10 as a base for those patches and try to apply beaglebone patches over them?
Best regards, Matti lauantai, 2. marraskuuta 2013 18.55.50 UTC+2 [email protected] kirjoitti: > > Hi Tom, > I had a look on those patch series. Just to check: I found 3 of v2 > (2013-08-14 x 3, 2013-09-10 x 3, 2013-09-30 x 4) and one v8 (2013-10-10 x > 5). Do your mean these series I should apply? > -Matti > > torstai, 24. lokakuuta 2013 17.42.03 UTC+3 Tom Rini kirjoitti: >> >> On Thursday, October 24, 2013 6:23:24 AM UTC-4, [email protected]: >>> >>> Hi! >>> >>> I am working on BeagleBone variant board using Ångström distribution. >>> Main difference is that NAND flash is installed on board. In fact my set-up >>> sounds pretty much same as in "NAND flash with BeagleBone >>> variant<https://groups.google.com/forum/embed/?place=forum/beagleboard&showsearch=true&showpopout=true&showtabs=true&hideforumtitle=true&parenturl=http%3A%2F%2Fwww.beagleboard.org%2FCommunity%2FForums#!searchin/beagleboard/nand/beagleboard/Gbtg8xZ_TNY/0QL5Q01PlbQJ>" >>> >>> case. >>> >>> *Short story:* >>> >>> UBIFS partition/volume formatted/created in Linux does not work in >>> U-Boot. UBI part command in U-boot fails. Later on Linux finds this UBIFS >>> corrupted. I don't have any problems if this UBIFS is accessed purely from >>> Linux. I have made NAND flash additions from am335x-evm.dts to BeagleBone >>> device tree. I have tried with ti,nand-ecc-opt = "bch8" (with kernel >>> options CONFIG_MTD_NAND_OMAP_BCH and >>> OMAP_ECC_BCH8_CODE_HW) and without. In the latter case those kernel >>> options were not active. >>> >> I think that at least part of the answer is that you need to enable >> CONFIG_SYS_NAND_ONFI_DETECTION. You may also need to apply some of Pekon's >> patches from >> http://patchwork.ozlabs.org/project/uboot/list/?submitter=17320&state=*(there >> are 3 series there as of this writing, 2 v2's and a v8, you should >> apply all 3 series, and in the right order, saving each series to an mbox, >> and using git am -3 / git am --abort when they fail should help get the >> right order sorted out quickly). >> >> -- >> Tom >> > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out.
