Addicore 5V 1.5A Positive Voltage Regulator L7805CV
On Wed, Mar 5, 2014 at 10:52 AM, Gerald Coley <[email protected]>wrote: > That particular regulator can have different pinouts. I have been bitten > before. So double check that based on the supplier. > > What voltage are you seeing on the output? I believe the best you can get > out of that regulator without a big heatsink is maybe 500mA which is > borderline for the BBB. You are dropping 6.7V across the regulator. > > Gerald > > > > On Wed, Mar 5, 2014 at 8:57 AM, Dorian Levy <[email protected]> wrote: > >> On Mar 4, 2014 7:42 PM, "Gerald Coley" <[email protected]> wrote: >> >>> Can you share a schematic with me? I can't visualize what you are doing. >>> >>> Gerald >>> >>> >>> >>> On Tue, Mar 4, 2014 at 5:05 PM, Dorian Levy <[email protected]>wrote: >>> >>>> I am building a robot that uses an 11.7V battery. I tried attaching a >>>> 5V regulator to the T5(+)/T8(-) (pins with the T6(SENSE) bridged to T5 and >>>> a 10K resistor between T8(TS) and ground. The board only stays on for about >>>> thirty seconds then shuts down. Is it because of the TS? What type of >>>> thermistor does it use? Or should I try to use the barrel jack since >>>> it's not directly connected to a battery? >>>> >>>> -- >>>> For more options, visit http://beagleboard.org/discuss >>>> --- >>>> You received this message because you are subscribed to the Google >>>> Groups "BeagleBoard" group. >>>> To unsubscribe from this group and stop receiving emails from it, send >>>> an email to [email protected]. >>>> For more options, visit https://groups.google.com/groups/opt_out. >>>> >>> >>> -- >>> For more options, visit http://beagleboard.org/discuss >>> --- >>> You received this message because you are subscribed to a topic in the >>> Google Groups "BeagleBoard" group. >>> To unsubscribe from this topic, visit >>> https://groups.google.com/d/topic/beagleboard/-Zb4VUlh5Mg/unsubscribe. >>> To unsubscribe from this group and all its topics, send an email to >>> [email protected]. >>> >>> For more options, visit https://groups.google.com/groups/opt_out. >>> >> -- >> For more options, visit http://beagleboard.org/discuss >> --- >> You received this message because you are subscribed to the Google Groups >> "BeagleBoard" group. >> To unsubscribe from this group and stop receiving emails from it, send an >> email to [email protected]. >> For more options, visit https://groups.google.com/groups/opt_out. >> > > -- > For more options, visit http://beagleboard.org/discuss > --- > You received this message because you are subscribed to a topic in the > Google Groups "BeagleBoard" group. > To unsubscribe from this topic, visit > https://groups.google.com/d/topic/beagleboard/-Zb4VUlh5Mg/unsubscribe. > To unsubscribe from this group and all its topics, send an email to > [email protected]. > For more options, visit https://groups.google.com/groups/opt_out. > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out.
