Try hitting the reset and power buttons? http://elinux.org/images/7/76/CONN_REVA5A.jpg On Jun 1, 2014 1:34 PM, "Jared Turner" <[email protected]> wrote:
> Ya, it was powering the board fine for the past 6 months. I checked the > voltage, 5.14v > > On Sunday, June 1, 2014 2:21:27 PM UTC-5, William Hermans wrote: >> >> Did you check to see if the barrel plug had correct polarities ? >> >> >> On Sun, Jun 1, 2014 at 9:59 AM, Jared Turner <[email protected]> wrote: >> >>> I have been trying to get my BBB to work with LinuxCNC. Everything was >>> working fine until I tried to power it up today. After I plugged it in, the >>> power light didn't come on, or any other lights. Was using an AC/DC >>> converter from Adafruit, also tried usb, no luck. Is it dead? >>> >>> -- >>> For more options, visit http://beagleboard.org/discuss >>> --- >>> You received this message because you are subscribed to the Google >>> Groups "BeagleBoard" group. >>> To unsubscribe from this group and stop receiving emails from it, send >>> an email to [email protected]. >>> For more options, visit https://groups.google.com/d/optout. >>> >> >> -- > For more options, visit http://beagleboard.org/discuss > --- > You received this message because you are subscribed to the Google Groups > "BeagleBoard" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > For more options, visit https://groups.google.com/d/optout. > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
