Contact cicuitco, and ask for an RMA. No power LED from either barrel jack or USB port is not a good sign.
On Mon, Jun 2, 2014 at 6:03 AM, Eric Fort <[email protected]> wrote: > Since you're booting from SD card is the card Fully seated? Just > checking, as it's in a spot easily bumped and I've knocked it out a couple > times without realizing it then thought "oh, what happened, it's dead!". > Also to boot from SD you need to depress the boot switch. really though to > do much debugging on the black you need a serial console cable. you can > also check which of the power rails are up. do you have 3v3 on the > headers? What do the 4 lights show? Also what voltage are you showing on > the power adapter under load and across both vcc_5v and sys_5v. If you > have any capes stacked / plugged in unplug them and test the black alone. > Remember to simplify. no matter what, all the best in getting things going > as I too have done stupid things that set me back a week or more. the good > news is that you will get past it and get things working. > > Eric > > > On Sun, Jun 1, 2014 at 9:46 AM, <[email protected]> wrote: > >> I have been trying to configure LinuxCNC on my BBB for some time. >> Everything was almost working, but when I tried to turn on the BeagleBone >> today, it wouldn't start. No power led, nothing. I was using the AC/DC >> converter I got from Adafruit, so it's not low quality (I assume). I also >> tried plugging it in via usb, same result. Any ideas? >> >> -- >> For more options, visit http://beagleboard.org/discuss >> --- >> You received this message because you are subscribed to the Google Groups >> "BeagleBoard" group. >> To unsubscribe from this group and stop receiving emails from it, send an >> email to [email protected]. >> For more options, visit https://groups.google.com/d/optout. >> > > -- > For more options, visit http://beagleboard.org/discuss > --- > You received this message because you are subscribed to the Google Groups > "BeagleBoard" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > For more options, visit https://groups.google.com/d/optout. > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
