You need g_ether.ko module. You can check it is loaded. On Sun, Dec 6, 2015 at 7:44 PM, hllpc <[email protected]> wrote:
> Same Issue here. > > Il giorno venerdì 30 ottobre 2015 18:13:55 UTC+1, Alex ha scritto: >> >> Hi, >> >> I am using ubuntu 14.04 (from Robert Nelson <https://rcn-ee.com/>) with >> a custom 3.15.10-bone8 kernel on Beaglebone Black. HDMI is disabled. >> When I plug the board to a PC, Beaglebone powers up but the PC does not >> recognize that a USB device is connected to it. I have installed the >> drivers for network-over-USB which is recommended on >> Beagleboard.org/getting-started too. Moreover, I cannot ssh into it using >> 192.168.7.2 eventhough I have set up my /etc/network/interfaces. >> ubuntu@arm $ ifconfig usb0 >> usb0 Link encap:Ethernet HWaddr d2:56:2f:23:1d:e2 >> inet addr:192.168.7.2 Bcast:192.168.7.3 Mask:255.255.255.252 >> UP BROADCAST MULTICAST MTU:1500 Metric:1 >> RX packets:0 errors:0 dropped:0 overruns:0 frame:0 >> TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 >> collisions:0 txqueuelen:1000 >> RX bytes:0 (0.0 B) TX bytes:0 (0.0 B) >> >> >> Is there some modules that I need to run or compile to Kernel to bring >> the client USB up? How should I configure the linux to be seen by PC when >> connected from mini USB? >> Thanks for any help. >> > -- > For more options, visit http://beagleboard.org/discuss > --- > You received this message because you are subscribed to the Google Groups > "BeagleBoard" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > For more options, visit https://groups.google.com/d/optout. > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
