GND (pin 1 on P9 rail) is connected to the arduino's GND & my protoboard's GND rails
On Friday, June 10, 2016 at 4:31:59 PM UTC-4, RobertCNelson wrote: > > On Fri, Jun 10, 2016 at 3:30 PM, <[email protected] <javascript:>> > wrote: > > I am using Beaglebone Black. I have connected pin 1 (tx) of the arduino > to > > the rx input of my voltage level shifter, and then the result into pin > 26 > > (UART1_RX) of the BBB. I have wired pin 0 of the artuino (rx) in a > similar > > manner to pin 24 of the BBB. > > So just two pin's... Where's your ground pin connected? > > Regards, > > -- > Robert Nelson > https://rcn-ee.com/ > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/beagleboard/a766020e-b49b-43e8-b511-9d3a81b5f2f2%40googlegroups.com. For more options, visit https://groups.google.com/d/optout.
