On Wed, Nov 1, 2017 at 1:14 PM, Tracy Smith <[email protected]> wrote: > E17 and E18 we want to use that are designated as possible CAN1 pins on the > BeagleBone Black schematic. > > Not using a different overlay, using the existing 4.14 kernel and 2017 I > boot that Robert Nelson suggests using for the BBB. But we need to pinmux > for E17 and E18 because the TI pinmuxing tool finds no conflict with these > two pins on our custom board. I’ll go back and check the CAN1 but prior to > Roberts changes last week that did not use the P9 expansion header, the unit > pinmux used different pins CAN1 I believe. With the P9 expansion header, > can’t use Roberts overlay because there is no P9 expansion header on our BBB > board. I’ll go back look at the pins for CAN1 prior to then P9 overlay > changes from last week by Robert.
What i suggested, assumed you were using a BBB. Thus since you have a custom board, it's all null and void.. Use TI's pinmux tool and properly route your can signals. Regards, -- Robert Nelson https://rcn-ee.com/ -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/beagleboard/CAOCHtYjL7P4v%3DVaF9ZQ%2BV7%3DE2EvCzUZzZt1d_zY-w52XQfDu1g%40mail.gmail.com. For more options, visit https://groups.google.com/d/optout.
