Dear Robert, all, thanks for your response.
I tried your command (without luck): "Wifi SSID set Wifi passphrase set Enabled tethering for wifi (if I stopped to already running tethering using connmanctl tether wifi off) or Error enabling wifi tethering: Already enabled" In the first setup, I can again connect to the board via WiFi (Windows) but I don't get an IP address. Any ideas what else to do/try? (I also cloned the eMMC from my BBBW (i.e., where the setup is up and running) to an SD card, flashed it to a second BBB with connected TL-WN722N, and also here it works "out-of-the-box". So it don't seems to be a problem of the used HW) Related question: can you guys point me to the file / configuration where the IP range (192.168.0.X) is set? As I'm planning to run several networks in parallel it would be good to have different IP ranges in use. Best regards and thank you very much, Marco 2018-01-04 16:50 GMT+01:00 Robert Nelson <[email protected]>: > On Thu, Jan 4, 2018 at 8:27 AM, <[email protected]> wrote: > > Dear all, > > > > I have to warm up this post again as I'm dealing with a minor problem > when > > setting my boards in AP mode: > > > > I have two BBBs: 1 BBBW and one BBB rev. C > > > > On BBBW (4.4.30-ti-r64) the AP is started automatically, I can use > > /var/lib/connman/settings file to set the SSID and the passphrase, and I > can > > connect to this board and get an IP in the range of 192.168.0.X > > > > On BBB with a TP-Link TL-WN722N (4.4.91-ti-r133) I try to do the same. > > Therefore, I uncommented to connman line in /etc/network/interfaces and > > edited the /var/lib/connman/settings (same setting as above). When I > restart > > the board I can see the SSID and even connect (from Windows) but I don't > get > > an IP. --> So I think I have to change another small thing to get it > working > > 100% (a problem with the DHCP?). Can you please point me towards the > right > > direction??? Would be great! > > Give this a shot: > > sudo connmanctl tether wifi on ${wifi_ssid} ${wifi_password} > > Regards, > > -- > Robert Nelson > https://rcn-ee.com/ > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/beagleboard/CAEFd7CsF%2Bz9YzuJtUBV4sfgrbUcv8ru%3DHO7%3D-JuM9eSg8ih%2B3g%40mail.gmail.com. For more options, visit https://groups.google.com/d/optout.
