I am trying to get the kernel driver for the ssd1306 working with the PocketBeagle USB HUB cape which has a 64x32 SSD1306 display ( https://www.tindie.com/products/microwavemont/oled-with-24-port-usb-hub-cape-for-pocketbeagle/) I know it is physically working as I can use it via user-mode I2C. I believe a small change is needed to support the unusual 64 pixel width of this board. I have built and loaded a new kernel and have a .dtbo loaded via u-boot with 4.4.88-ti-r128 kernel. It shows up in /proc/device-tree correctly (at least as far as I can tell - the entries match the dts values). I am missing how to get this connected to the framebuffer world - there is no /dev/fb0 showing up. I see the config options appear to be enabled (I am using the defconfig). My googling did not turn up anything other than others stuck in a similar situation on RPi's.
Mark -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/beagleboard/CAL8ugEdZAp6n6Upwf0%2B%3DSV%3D%2BE35hDRPABM5Dgb21%2B6Dq3eC9GA%40mail.gmail.com. For more options, visit https://groups.google.com/d/optout.
