On 01/07/2018 05:59 PM, Mark Grosen wrote:
I am trying to get the kernel driver for the ssd1306 working with the
PocketBeagle USB HUB cape which has a 64x32 SSD1306 display
(https://www.tindie.com/products/microwavemont/oled-with-24-port-usb-hub-cape-for-pocketbeagle/)
I know it is physically working as I can use it via user-mode I2C. I believe a
small change is needed to support the unusual 64 pixel width of this board. I
have built and loaded a new kernel and have a .dtbo
And what does your device tree overlay look like?
loaded via u-boot with 4.4.88-ti-r128 kernel. It shows up in /proc/device-tree
correctly (at least as far as I can tell - the entries match the dts values). I
am missing how to get this connected to the framebuffer world - there is no
/dev/fb0 showing up. I see the config options appear to be enabled (I am using
the defconfig).
And which options did you enable/are enabled?
My googling did not turn up anything other than others stuck in a similar
situation on RPi's.
--
For more options, visit http://beagleboard.org/discuss
---
You received this message because you are subscribed to the Google Groups "BeagleBoard" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
To view this discussion on the web visit
https://groups.google.com/d/msgid/beagleboard/b2971667-597a-6281-a5a1-232f2ae6801f%40lechnology.com.
For more options, visit https://groups.google.com/d/optout.
