Followed the instructions. Two user leds turned on They did not blink just stayed like that for a while I tried yhe sd with the kali image and the lights did not even turn on. Removed the sd chip and applied power and angstrom booted up with the gui
n Friday, February 14, 2020 at 9:13:49 AM UTC-6, RobertCNelson wrote: > On Fri, Feb 14, 2020, 8:24 AM <ddch...@gmail.com> wrote: > > ok. so the image i was trying to flash to my BBB was a 4gb sd chip bootable. > not a flash image. if i put the 4gb sd bootable version in the sd slot then > i should have seen the device boot but it didnt. i was expecting a flash > process. right there i see a red flag. > why would the bootable sd not boot? the image is corrupt? am i supposed to > download and create the image using the BBB? Ive been doing everything on my > laptop. > > > > > It will boot, just follow these directions exactly.. > > > Plug in SD card. > Using your finger nail, hold down the boot button. > Insert power with other hand. > Once LED's start to blink, remove finger nail from button. > > > Regards, F -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to beagleboard+unsubscr...@googlegroups.com. To view this discussion on the web visit https://groups.google.com/d/msgid/beagleboard/44a38cd4-b044-4f37-9071-67875647c7ff%40googlegroups.com.