I got it fixed! There is a squeeze command, which is basically like empty the recycle bin - it clears out and reclaims the space of deleted files, thereby freeing my up like 23MB of space in FLash.
Once i had the space, it was easy to copy the new OS image over to both supervisor modules, rebooted and now i can see all my ethernet Line Card Modules. hooray! phew! thor :------------------------------:----------------------------------------: : Highpoint Lowlife Records -- indie/electronic noise since 01 ---: : http://www.highpointlowlife.com/ -------------------------------------: :------------------------------: On Thu, 10 Nov 2005, P a u l Guth wrote: > In the olden days you could transfer directly over the serial console, > I think using xmodem/crc or some such arcanity. Dunno if it's even > possible anymore and it would royally suck to do 15 meg images that > way.... > > On Thu, Nov 10, 2005 at 04:50:25AM -0800, thorsten Sideb0ard wrote: > > > > Anyone here used a PCMCIA/PC Card with a Catalyst Switch? > > > > I'm trying to use a standard PC ATA card, and not a Cisco branded one, > > however i'm not sure if its possible or not. I've been searching Cisco.com > > and Google but cannot confirm or deny it. All Cisco documentation only > > speaks about Cisco cards. > > > > When I try to read it, it gives an error about bad device info block, > > which Cisco.com says is because its not formatted. WHen i try and format > > it i get an error about cannot find flash algorithm. > > > > I am in a real annoying Catch-22 situation... > > I just took delivery of a new Cat 6513 switch, which boots up fine, i can > > attach via teh console to both Supervisor modules and they seem fine, > > however it could not read any of the RJ45 switch modules/blades installed. > > After some helpdesk calls, my CatOS had to be upgraded to support the Line > > Modules. All the upgrade instructions involve tftp, so you need to use a > > Line Module to do the upgrade, but i need to do the upgrade to get my > > modules working. > > > > I was hoping i could use the PC Card to transfer the bin image from my PC > > to the Catalyst, but so far not having much luck. > > > > If any of you have knowledge or experience of a similar situation, any > > advice or ideas would be much appreciated.. > > > > cheers! > > thor > > > > :------------------------------:----------------------------------------: > > : Highpoint Lowlife Records -- indie/electronic noise since 01 ---: > > : http://www.highpointlowlife.com/ -------------------------------------: > > :------------------------------: > > > > _______________________________________________ > > Bits mailing list > > [email protected] > > http://www.sugoi.org/mailman/listinfo/bits > _______________________________________________ Bits mailing list [email protected] http://www.sugoi.org/mailman/listinfo/bits
