On Sun, Oct 12, 2014 at 11:11:27PM -0300, Fernando de Oliveira wrote:
> On 12-10-2014 23:07, Fernando de Oliveira wrote:
> > On 12-10-2014 22:36, Bruce Dubbs wrote:
> >> Ken Moffat wrote:
> >>
> >> I didn't do 4.3.1.2, but I did do 4.3.2.2.  The log is about 35K lines,
> >> but the word 'tested' is not in there at all.

 Now I'm on a desktop box, I can see that its log does not mention
'tested' either.  But I had not changed my script, apart from
setting it to only build en_GB on the netbook.

> >>
> >> Attached is the script I used.  Change the value of base_sbu as
> >> appropriate.
> >>
 I had already started a repeat using just 'make', to see if it
differs - I'll find out in a day or two ;-)

 On the netbook, the SBU is 532.605s [ from timing a repeat of
binutils pass 1 after booting - the initial SBU using a very old
version of gcc was less slow. ]

> >> Did you by by chance run out of disk space?

 I would have thought that was unlikely, '/' is about 16GB.  At the
moment (two hours or so into the build) I have 5.3GB available/ :
perhaps that was indeed the reason it failed.
> > 
> > Do you remember the problems I had with LO? Log was just that. This
> > time, I intentionally reproduced, by building via ssh, untill it failed.

 I vaguely remember somebody had problems.

> > Then, I went to the machine, in an x-terminal, cd into the failed
> > source, make build, and it completed. Armin hada similar problem in
> > chroota. I included a note in the book:
> > 
> > " [Note]
> > Note
> > 
> > Building this package in a graphical environment is recommended. There
> > have been reports of build failures, when using chroot or ssh."

 Yeah, but this was run from rxvt-unicode in X.
> 
> *Do not make clean*

 Too late, but anyway, if I cannot build it from a script, I'm not
interested ;-)

ĸen
-- 
Nanny Ogg usually went to bed early. After all, she was an old lady.
Sometimes she went to bed as early as 6 a.m.
-- 
http://lists.linuxfromscratch.org/listinfo/blfs-dev
FAQ: http://www.linuxfromscratch.org/blfs/faq.html
Unsubscribe: See the above information page

Reply via email to