On 24/03/2019 19:51, Pierre Labastie via blfs-dev wrote: > On 24/03/2019 18:35, Pierre Labastie via blfs-dev wrote: >> On 24/03/2019 16:53, Bruce Dubbs via blfs-dev wrote: >>> On 3/24/19 9:43 AM, Pierre Labastie via blfs-dev wrote: >>>> On 23/03/2019 22:08, Pierre Labastie via blfs-dev wrote: >>>>> On 23/03/2019 21:22, Bruce Dubbs via blfs-dev wrote: >>>>>> On 3/23/19 12:13 PM, Pierre Labastie via blfs-dev wrote: >>>>>>> >>>>>>> Summary: Error in plasma-workspace, appeared wirth cmake-3.14 >>>>>> >>>>>> I'm surprised that the problem didn't show up in kf5 or the earlier >>>>>> plasma >>>>>> packages. I have not built plasma since tests for the 8.4 release and >>>>>> wasn't >>>>>> planning on rebuilding the next version until May. >>>>>> >>>>>> The current version of plasma is 5.15.3. Can you check if the problem is >>>>>> fixed there? >>>>>> >>>>> >>>>> [...] >>>>> >>>>> Ok, I can try 5.15.3. I already have part of plasma installed, but I >>>>> think I >>>>> can remove it with porg. If so, I'll be able to measure disk space. Hmm, >>>>> thinking about that, I'm not sure how to proceed: take the maximum of the >>>>> disk >>>>> spaces before each source removal? >>>>> >>>> >>>> This problem is fixed in 5.15.3. It took me some time to realize that some >>>> packages had versions 5.15.13.1 or 2, and that those versions were to be >>>> used! >>>> >>>> Making another build because I screwed up measuring sizes... >>> >>> To measure size of plasma, I just take the difference of /opt/kf5 before and >>> after plasma is installd. >>> >> >> What I did: >> echo Start size: $(sudo du -skx --exclude home /) >> just after downloading, >> then >> echo Size after $packagedir: $(sudo du -skx --exclude home /) >> before each rm -rf $packagedir. >> >> Then took the maximal "Size after $packagedir" (reached after plasma-desktop) >> minus Start Size. This gives me the estimated disk space required (found >> around 360 MB) >> Then the installed size is computed as you say (found around 260 MB). >> >> Hope it is OK > > Done at r21385. I think I'll test KF5...
KF5-5.55 builds OK with cmake-3.14, but the book is wrong: the sed for kcodecs must be run after untarring the file and changing to the build tree... Will fix the book. Pierre -- http://lists.linuxfromscratch.org/listinfo/blfs-dev FAQ: http://www.linuxfromscratch.org/blfs/faq.html Unsubscribe: See the above information page
