Well, I'm not sure what you needed to see on the CONFIG_NET, but here's what the config file contains:
CONFIG_NET=y CONFIG_NETFILTER=y CONFIG_NETDEVICES=y CONFIG_NET_ETHERNET=y CONFIG_NET_PCI=y And here's what the call to ip link show shows: 1: lo: <LOOPBACK,UP> mtu 16436 qdisc noqueue link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00 2: e1000: <BROADCAST,MULTICAST> mtu 1500 qdisc noop qlen 1000 link/ether 00:06:5b:cd:28:1f brd ff:ff:ff:ff:ff:ff If I'm reading this right it looks like the hardware is there and the module is loaded correctly, right? Thanks -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Dan Nicholson Sent: Friday, June 30, 2006 5:30 PM To: BLFS Support List Subject: Re: Dhcpcd not working On 6/30/06, David Barron <[EMAIL PROTECTED]> wrote: > My first goal is to get DHCP working, so I went through the steps for dhcpcd > without any difficulty. But when I reboot I'm getting "Interface eth0 > doesn't exist" errors. > > I used the livecd as my host system for the installation and it showed my > network module was e1000, so when I compiled the kernel I made sure support > for e1000 was included as a module. When I use the lsmod command it does > show e1000 as loaded, but under Used by it just shows a 0. Well, it's seems OK that it shows 0. My ethernet driver is sundance, and it shows Used by 0. Besides, the module wouldn't have been loaded if the device wasn't in use. Did you add networking support to your kernel? CONFIG_NET=y/m and friends? What's the output from "/sbin/ip link show"? -- Dan -- http://linuxfromscratch.org/mailman/listinfo/blfs-support FAQ: http://www.linuxfromscratch.org/blfs/faq.html Unsubscribe: See the above information page -- http://linuxfromscratch.org/mailman/listinfo/blfs-support FAQ: http://www.linuxfromscratch.org/blfs/faq.html Unsubscribe: See the above information page
