The experts always tell you to dry fit all fittings before committing to glue. I admit I don't always do that and I have got caught once or twice.
Most of the A B S fittings are three quarters deep but they also make some arc which adds a little to the length. I don't know if there is an absolute standard. There are at least two sweeps of elbows, a long and a short curve. The only way I know of calculating the additional length added by a fitting like an elbow for example is to set one opening on a flat surface and measuring from that flat surface to the top inside of the opposite opening. You will then have to account for the three quarters of an inch which disappears into the end of the fitting. PVC as is used in pressured water lines are all sharp bends, or at least any I have seen or used. I am pretty sure all that I have used are half inch deep but just now I don't have any spare 3/4 inch fittings to double check that with. My advice though is to always dry fit before applying the solvent. Sighted people draw pencil marks across the joints to line them up after when glue is applied so you don't have to glue them in situ. I have always winged it but you could lay masking tape across the joints then cut it with a razor knife before disassembling the fit and applying the solvent and then use the tape to line up the fittings correctly. Hope this gives you some helpful ideas. Dale Leavens, Cochrane Ontario Canada [EMAIL PROTECTED] Skype DaleLeavens Come and meet Aurora, Nakita and Nanook at our polar bear habitat. ----- Original Message ----- From: Edward Przybylek To: BlindHandyMan Sent: Tuesday, October 30, 2007 4:06 PM Subject: [BlindHandyMan] PVC Question For The Experts Hi all, I've done quite a bit of work with PVC pipe but, at times, when I glue the pipes together the parts turn out to be a little too long even though my measurements are very accurate. Is there anykind of a rule of thumb for taking a little off each measurement to make things go together better? Any help greatly appreciated. Take care, Ed Przybylek [Non-text portions of this message have been removed]
