[uucdigest]        Wednesday, February 16 2000        Volume 03 : Number 272



~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
| For all available Digest commands including unsubscribe/subscribe,
| visit the BMW UUC Digest page: http://www.uucdigest.com
| Send SUBMISSIONS to [EMAIL PROTECTED]
| Complaints?  Send 'em to [EMAIL PROTECTED] if you must.
| Visit http://www.bubbaclub.com
| www.bimmers.com - "serving enthusiasts on the 'net"
| Visit http://www.bimmer.org - ultimate BMW bulletin boards!
| Subscribe to the Zionsville Autosport Parts Digest:
|   http://www.zionsvilleautosport.com/majordomo.htm
�����������������������������������������
In this BMW UUC Digest:

       [uuc] Re: <WOB>  80's Cars Are Best
       [uuc] Affording an M3
       Re: [uuc] Re: Re: E28> Removing Rear Emblems

----------------------------------------------------------------------

Date: Tue, 15 Feb 2000 23:03:31 -0800
From: John Edward Miller <[EMAIL PROTECTED]>
Subject: [uuc] Re: <WOB>  80's Cars Are Best

> Advantage about early 1980s BMWs. Valve adjustment is a snap with
> the right gauges, and everything else is easy to lube and/or
> calibrate. Cost of tune-up, a few bucks for oil plus a Saturday
> or Sunday afternoon. This is why I drive an '80s BMW.

Was browsing EBay earlier...what looked to be a clean '86 160K-mile 5-speed 
535i went for $2276...were I the high bidder, I'd be surprised as hell.

John.

------------------------------

Date: Tue, 15 Feb 2000 23:36:22 -0800
From: Jim Ochi <[EMAIL PROTECTED]>
Subject: [uuc] Affording an M3

At 04:25 PM 2/15/00 -0500, VITOLO_JONA"@LNMTA.bentley.edu wrote:
>
>Well, to answer your question-I can't afford an M3. My parents bought the car
>for me(hold on before you flame) I discovered the M3 back in 1995 and my dad
>made a deal with me that if I got straight A's I could get the car. Well come
>graduation, I had a good gpa and my dad said I could get one. 

This idea that parents would bribe their offspring to get good grades by
offering a car is just totally repugnant to me.  Especially an expensive
car like the M3.  I had to get my car the old-fashioned American way - I
earned it.  I worked nonstop, going out evenings and weekends to sell
drugs, mug little old ladies for their Social Security money, and to steal
kidneys from tourists.  I had to spend many, many, many hours hanging
around the bus terminal, picking up young runaways to sell into slavery.

But, every time I rev up to redline, it just makes it all worthwhile.

Jim "Tongue fully in cheek.  My cheek." Ochi
[EMAIL PROTECTED]

------------------------------

Date: Tue, 15 Feb 2000 23:52:59 -0800
From: Jim Ochi <[EMAIL PROTECTED]>
Subject: Re: [uuc] Re: Re: E28> Removing Rear Emblems

At 09:08 PM 2/15/00 -0800, John Bolhuis wrote:
>On Tue, 15 Feb 2000, Jim Ochi wrote:
>> Try using a belt sander to remove the adhesive, after you remove the emblem
>> with a pickup truck.  40 grit sandpaper takes it right off.  Just be sure
>> not to sand through your trunk.
>
> The belt sander won't get down in the crease, and I'm too lazy to use
>a sanding block.  Will sandblasting work?
>

Sheesh - what are you, a hack mechanic or something?  A
sandblaster....everyone knows that if the belt sander doesn't fit, you go
straight to the torch...Man o man - glad you're not working on my car!

Jim Ochi
[EMAIL PROTECTED]

------------------------------

End of [uucdigest] V3 #272
**************************

_________________________________________
| Please visit these UUC-approved BMW parts vendors/service providers:
| (listed alphabetically)
| Bonneville Motorwerks . http://www.bonnevillemotorwerks.com
| Circle Tire Co. (used & classic BMW parts) e-mail [EMAIL PROTECTED]
| Curry's Auto Service .  http://www.currysauto.com
| Eurosport . http://www.eurosport-hp.com
| Koala MotorSport . http://www.koalamotorsport.com
| Taylor BMW - http://www.taylorbmw.com - Doc Bimmer!
| The Ultimate Garage . http://www.ultimategarage.com
| UUC Motorwerks . http://www.uucmotorwerks.com
| Zionsville Autosport . http://www.zionsvilleautosport.com
����������������������������������������

Reply via email to