Hi All, the subject says it all! On my BrailleNote mPower, when I connect my USB embosser, I'm given a "Card not Recognised" prompt. Printing works fine.
1. connect a Basic S/D with firmware version 10.x to the BrailleNote mPower BT using the USB host port. 2. Switch the BrailleNote on and set the embosser port to USB, ensure the visual display is off, and set ActiveSync to serial. 3. Switch the Braille embosser on. A message is displayed: "Card Not Recognised". Press enter and ignore this message. 4. Attempt to emboss the Demonstration Document, located in the general folder of the flash disk. 5. Upon completion, a further message is displayed: "Embosser Error: . the specified network resource or device is no longer available". The BrailleNote does not emboss the document. 6. subsequent tries result in the same message, but at the emboss or setup prompt. Does anyone know how to fix this, and if so, could they please get back to me as soon as possible, as this will have an impact on my school work. Thanks in advance, Matthew --- You can contact me in the following ways: E-mail: [EMAIL PROTECTED] Secondary E-mail (only if E-mail doesn't work): [EMAIL PROTECTED] MSN Messenger: [EMAIL PROTECTED] Skype: matthewhorspool And as of September 1, you can visit www.TheHorspools.com for something that's hopefully better than what's up there now! ___ To leave the BrailleNote list, send a blank message to [EMAIL PROTECTED] To view the list archives or change your preferences, visit http://list.humanware.com/mailman/listinfo/braillenote
