Hi Katie,
Did you run the prepare sd card for upgrade before starting the
upgrade? YOu should put the file on to your mpower, then run the
prepare card for upgrade. Thenput the file back on thecard and
try again. Make sure the catrd is smaller than 512 mb.
Stacey and Chesley
----- Original Message -----
From: "Katie Frederick" <[EMAIL PROTECTED]
To: <[email protected]
Date: Fri, 14 Jul 2006 14:41:23 -0400
Subject: [Braillenote] upgrading the mPower BT from 7.0 to 7.1
Hello List:
I'm trying to upgrade my mPower from KS 7.0 to 7.1.
I installed the 7.0 upgrade from the online site, and then later
received the software on an SD card because I was entitled to the
upgrade.
I successfully have been using 7.0, but felt I should upgrade to
7.1. So, I inserted the SD card into my PC which contained the
KS 7.0 files, and just downloaded the 7.1 file onto the card from
the website.
Everything went well until I started to upgrade. I hit dots 4
and 6 with the reset button, that part seemed ok. Then the
instructions said something about holding down dots 1 and 2, but
that didn't seem to work. So, I tried hitting the dots 4 5 with
the reset, and that didn't seem to produce any results.
I actually had to do a service reset, because the unit froze with
the message "update bootloader" on the braille display.
I really would like to upgrade to 7.1 however, it is not urgent,
but if I can do it then I will.
Has anyone else experienced trouble upgrading? And, what am I
doing wrong or not doing...any ideas?
Thanks,
Katie
___
To leave the BrailleNote list, send a blank message to
[EMAIL PROTECTED]
To view the list archives or change your preferences, visit
http://list.humanware.com/mailman/listinfo/braillenote
___
To leave the BrailleNote list, send a blank message to
[EMAIL PROTECTED]
To view the list archives or change your preferences, visit
http://list.humanware.com/mailman/listinfo/braillenote
