Hi All,
I am embossing a six-page document that has been formatted as a
brf document using the Blazer connected to the BN by means of
the serial port. The document is complete with page numbers and
appropriate spacing. Here are my steps:
1. Insert paper in Blazer with paper positioned ready to go.
2. Turn off blazer.
3. Find the file on the BN, open it and close it.
4. Choose emboss at the Keyword options menu.
5. Turn on Blazer
6. Choose "y" to emboss a single copy.
7. Repeat steps 4-6 to emboss a second copy of the document.
Here comes the mistery! If I either choose to emboss one copy
and then immediately emboss a second copy, or I choose to emboss
two or 3 copies at once, there appears a "7" at the top right
corner of the first page of the second document and third
document. I have not chosen to emboss more than 3 copies without
turning off the Blazer, but I will now assume that a "7" would
appear at the top, right corner of each copy after the first
copy. From then on there are no page numbers except for those
that are embedded in the document already. I have checked the
Layout list on the BN and "Page Numbering" is set to "No."
I can keep this from happening if I turn the blazer off and then
on again after embossing a single copy of the document.
I have seen a serial port connection put extra dots at the top of
a document if its buffer is not emptied before starting
embossing. That is why I turn it off. However, it seems "smart"
to put a "7" after page "6". Then, why does it not continue the
numbering. Better that it does not, though.
Is this a bug?
Any suggestions would be appreciated. If this needs the
attention of tech support for a possible fix, I would like to be
directed as to how to get their attention for this matter.
Thanks in advance,
Joleen
___
To leave the BrailleNote list, send a blank message to
[EMAIL PROTECTED]
To view the list archives or change your preferences, visit
http://list.humanware.com/mailman/listinfo/braillenote
