Gail, Did you remember to plug in your AC adapter?
Also, you don't get speech during the upgrade, at least I didn't. And, the braille display will be blank for the first few seconds after the tones and then it should say the word loading followed by a percentage which will gradually increase. Also, are you sure the sd card was properly formatted to accommodate an upgrade? Finally, were you able to get your MPower to respond and run under the previous keysoft you already had installed? Jusst trying to explore all the possibilities most likely to give problems during the upgrade. Don On Mon, 06 Nov 2006 22:38:07 -0600, Gail Bryant wrote: I downloaded KS7.02 bild 47 maintenance upgrade and coppied it to an SD card. Then I followed the instructions for upgrading the m-power. I got the tones and then everything went blank. No speech no braille. Can someone help me out? Gail Bryant Columbia Braille Teaching Services L.L.C. 1212 London Drive Columbia, MO 65203-2012 Phone: 573 817-5993 Cell: 573 268-4962 Provides quality braille and software instructional services to blind children/adults [EMAIL PROTECTED] ___ To leave the BrailleNote list, send a blank message to [EMAIL PROTECTED] To view the list archives or change your preferences, visit http://list.humanware.com/mailman/listinfo/braillenote __________ NOD32 1.1856 (20061106) Information __________ This message was checked by NOD32 antivirus system. http://www.eset.com ___ To leave the BrailleNote list, send a blank message to [EMAIL PROTECTED] To view the list archives or change your preferences, visit http://list.humanware.com/mailman/listinfo/braillenote
