Hi folks, I'm writing to see if any one else has had the same problems with a braille display. First off, the equipment. i've got an MPower transplant so I'm using an old display with 32 cells. I've been having some strange problems. A few weeks ago the display would choose to show strange characters in the first two or three cells. Often they were simply the correct characters, but missing a dot or two. Last night I plugged in the unit as it had run down completely. When I turned it on the display read "starting keysoft" Then the display went blank. I heard two high tones and some low tones but no speech and no braille. I toggled the speech on and it started talking saying the braille display is not active or not responding or something like that. I went to options and braille display. I hit enter and heard two low beeps and tot the same message. I tried to exercise the display. It went blank, but the kind of blank where you know the dots are being held down. One dot was showing in cell 1. I did several resets finally trying to restart the display from the options menu. It worked, bun only after a few resets, both hard and 456 resets. It is important to note that the display would always show "startink keysoft" so I know without a doubt that the display is working. Though the display is still wolking, it is not reliable. Characters are often displayed incorrectly. This is not to cast blame, but all of this seems to have started after having had my space bar adjusted at CSUN. Any thoughts? Rusty
___ Replies to this message will go directly to the sender. If your reply would be useful to the list, please send a copy to the list as well. To leave the BrailleNote list, send a blank message to [EMAIL PROTECTED] To view the list archives or change your preferences, visit http://list.humanware.com/mailman/listinfo/braillenote
