I too have been experiencing this behaviour of my ethernet card.
It is something that has crept in with recently issued upgrades.
Until your message, I had thought it was just my Mpower that was
effected. I even purchased a new ethernet card, believing my old
one to have become faulty; an expensive diagnosis, for it behaves
in the same way. I have discovered that sometimes a reset with
dots 123 held down will do the trick; otherwise, I take out the
ethernet card, put in a standard cf card. The Mpower will
normally pick up this card. Once it has acknowledged it, the
unit appears to also once again accept the ethernet card, but
never with the unit turned on. Perhaps this will stabilise with
future development.
Don Cooper.
___
Replies to this message will go directly to the sender.
If your reply would be useful to the list, please send a
copy to the list as well.
To leave the BrailleNote list, send a blank message to
[EMAIL PROTECTED]
To view the list archives or change your preferences, visit
http://list.humanware.com/mailman/listinfo/braillenote
