Hi all,
Have you seen this one before ...
I first saw it some months back when I tried to load a .BRF file. After
going through the Options and setting them as Default, I pressed E-Chord and
got a message , "Reached the end of the file". There was nothing I could do
to load it right then (in public) and I didn't try a reset. ... (I
thought).
I solved my problem by replacing a few files from another source and they
appeared fine.
Today I found I had lost one of those files so retrieved it from my
husband's mPower. On loading it into the PK (as described above) I got the
same error ...
I repeated the process using the mPower and - yes - it loaded fine!
After performing a C3-C4reset on the PK, I reloaded and this time it worked
...
The file is only 59KB (hardly giant size) and I'm not sure where the problem
lies. I didn't think to check memory availability before performing this
process and wonder just what is clogging up the works here.
Any ideas whether this is likely to be a memory issue or something else and
whether it should be brought to the attention of HW staff?
All comments most welcome. Thanks.
--
Carol
[EMAIL PROTECTED]
___
Replies to this message will go directly to the sender.
If your reply would be useful to the list, please send a
copy to the list as well.
To leave the BrailleNote list, send a blank message to
[EMAIL PROTECTED]
To view the list archives or change your preferences, visit
http://list.humanware.com/mailman/listinfo/braillenote
