Hello. Todd I have some questions regarding the BIII- 1) How does the hole size in the front panel compare on original digital controller to the PID? 2)Does the PID use a different thermocouple, and does it install in the same well as the original ? 3) Also, is the heater coil in the steam boiler changed from 950 w to 1200 watts? 4) Does the PID show overshoot in degrees,or does it stop at the preset value?
Lastly, can I purchase from WLL a rebuild kit for my E-61 head? (All the washers and the springs) Thanks, Dennis Keating ----- Original Message ----- From: Todd Salzman To: [email protected] Sent: Tuesday, January 06, 2009 8:13 AM Subject: Re: Brewtus lll Hello, I just finished the instructions for the Brewtus III and you will find them attached. This is version 1.1. As we go I will add to it as needed. Please feel free to send me your input so that I can make sure that it is exactly what new and expereicned users would like. Our PID was specially programed for the Brewtus III. We have made it so that the temperature on the display will show the temperature in the boiler minus the offset. I am surprised that the K2 grinder can not grind fine enough. I would think that it needs new burrs or the coffee is old or dry. We set up all the machines so the brew pressure should be good. Thanks very much. Todd Salzman Whole Latte Love --~--~---------~--~----~------------~-------~--~----~ You received this message because you are subscribed to the Google Groups "Brewtus" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/brewtus?hl=en -~----------~----~----~----~------~----~------~--~---
