At 08:13 AM 6/29/2009, you wrote: >It may be overheating and tripping the high limit switch. See the >attached directions. > > >Please let us know if you need further assistance. > >With Regards, >The Technical Support Department >888-411-5282 >[email protected]
Unless I received a different version of the instructions than anyone else, I'd say they need quite a lot of work. The indicated picture is no where to be found and it neglects to indicate that one should follow a procedure something like this to set the pressure: Please if there is something really wrong with this, correct me so that no one here does anything that might get them in trouble. If your pressure was to high, start by turning the pressurestat adjustment screw 1 turn counter clockwise. Now you'll need to plug in and turn on the machine and allow it to fully warm up. Be extremely careful at this point as very dangerous things, both temperature and electricity are now exposed. After the machine is fully stablized, check to make sure the pressure is equal or below 1.2-1.4 bars, if not turn the pressurestat additional 1/2 turns counter clockwise and then let off steam into a pitcher for 15 seconds and allow the machine to stabilize again. Repeat until the stable pressure reading is at or below the recommended 1.2-1.4 bars. Now the pressure should be at or below 1.2-1.4 bars. If it's in the range 1.2-1.4 bar, you're finished, turn off and unplug the machine, let it cool and replace the panels removed in step one. If it's below 1.2-1.4 bar, turn the pressurestat 1/4 turn clockwise and wait a few minutes for the pressure to stabilize. Continue to adjust the pressurestat 1/4 turn clockwise at a time every 5 minutes until the pressure is stable at 1.2-1.4 bar. Now turn off and unplug the machine, let it cool and replace the panels removed in step one. And while it shouldn't be necessary, we'd recommend observing the pressure over the next few days to make sure it stays in the recommended range. If it doesn't seem stable it may be time to replace the pressurestat. Ira --~--~---------~--~----~------------~-------~--~----~ You received this message because you are subscribed to the Google Groups "Brewtus" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/brewtus?hl=en -~----------~----~----~----~------~----~------~--~---
