Hi Guys I have a Brewtus III PID with a rotary pump/
Woke up this morning to my brew group boiler showing 99C, started pulling a shot to check and was flash steaming as the water came out so suspect the reading was correct (set temp is 90c). Pulled some water through it for about 60 seconds and the temp started dropping. I switched my machine off left it for about 30 minutes and switched it on again. Steam pressure came up and the light for the steam boiler went of, brew temp was sitting at 70c and the light on the PID was indicating that it was powering the brew element but there is no rise in temp. I switched the machine off altogether and left it the whole day, brew temp has dropped down to 30c when I switch it on and does not rise at all. Would I be correct in assuming that this is probably a faulty brew group element? Anything else I should heck before dismantelling? Thanks JohnB -- You received this message because you are subscribed to the Google Groups "Brewtus" group. To unsubscribe from this group and stop receiving emails from it, send an email to brewtus+unsubscr...@googlegroups.com. To post to this group, send email to brewtus@googlegroups.com. Visit this group at http://groups.google.com/group/brewtus. For more options, visit https://groups.google.com/d/optout.
